Cleveland Golf
Cleveland Golf Cobalt Double End Mill 3/4 2FL
A cobalt double-end mill with a 3/4-inch shank, two flutes and a 30-degree helix for finishing operations
- TypeHole, Drill, Bore & Wire Gauges
- Cobalt construction resists heat during extended cutting
- Two-flute design clears chips efficiently in deep slots
- Double-ended square profile provides two fresh cutting edges
- 30-degree helix angle balances finish quality and feed rate
- Bright uncoated surface suits general-purpose milling applications
Square End Mill for Finishing
The Cleveland Golf Cobalt Double End Mill 3/4 2FL is a general-purpose cutting tool designed for finishing operations in milling machines. Its two-flute geometry and 30-degree helix angle promote smooth chip evacuation and a clean surface finish on a variety of workpiece materials. Machinists and maintenance technicians use it for precision slotting, profiling and plunge cuts where a square corner is required.
Bright Uncoated Cobalt Construction
The cutter is made from cobalt high-speed steel with a bright, uncoated finish and a corner radius of .000 inches for a true sharp corner. Cobalt material provides higher heat resistance and wear life than standard high-speed steel, allowing the tool to maintain edge integrity during extended finishing passes. The right-hand cutting direction suits conventional milling setups.
Double-Ended 3/4 Inch Shank Fit
A 3/4 inch diameter shank matches standard tool holders and collets without requiring reducer sleeves. The double-ended design places an identical square end on both sides of the tool, effectively doubling the usable cutting edges before replacement. Overall length of 5-5/8 inches and a 1-5/16 inch length of cut provide adequate reach for typical pocketing and facing tasks.
Highlights
- Cobalt construction resists heat during extended cutting
- Two-flute design clears chips efficiently in deep slots
- Double-ended square profile provides two fresh cutting edges
- 30-degree helix angle balances finish quality and feed rate
- Bright uncoated surface suits general-purpose milling applications
Specifications
| Brand | Cleveland |
|---|---|
| Type | Hole, Drill, Bore & Wire Gauges |
Questions about this item
How does the 30-degree helix angle affect chip evacuation when the mill is cutting in a CNC machine?
The 30-degree helix provides a moderate rake that lifts chips steadily without excessive vibration, helping maintain surface finish during finishing passes in steel and stainless.
What does the 3/4-inch shank diameter mean for toolholder compatibility?
It requires a 3/4-inch collet, end-mill holder, or shrink-fit chuck; the shank matches the cutting diameter so no reduction sleeve is needed.
How much clearance does the 5-5/8-inch overall length demand inside the machine envelope?
The tool occupies roughly 5-5/8 inches from spindle face to tip, so the work zone must allow that reach plus the 1-5/16-inch flute length.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
SIEMENS
SIEMENS 52PP2D2AB 30 mm Illuminated Push Button Red 24 V LED 1NO/1NC
$179.99
0.00208602BTC
In stock