We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
5/32 inch solid carbide straight flute drill bit, bright finish, 140 degree point

Chicago-Latrobe

Chicago-Latrobe 78594 5/32 in 140 Degree Solid Carbide Straight Flute Drill

SKU CH-G4SS-0RS53

A solid carbide straight-flute drill bit with a 140-degree point angle and 5/32 inch diameter for precise machining

  • TypeCutting Tools
  • Solid carbide construction resists wear in abrasive materials
  • 140 degree point angle enables self-centering on hard surfaces
  • Straight flute design clears chips efficiently in shallow holes
  • 5/32 inch fractional size matches standard tooling requirements
  • Bright uncoated finish suits general-purpose machining tasks

Chicago-Latrobe 78594 Drill

The Chicago-Latrobe 78594 is a solid carbide straight flute drill bit manufactured for precision hole making. It suits machinists and technicians who require a rigid, wear-resistant tool for accurate drilling operations.

5/32 in Capacity and Headroom

The 5/32 in fractional size provides a decimal equivalent of .15625 in with a 1 in flute length for standard reach. The 140 degree point angle and four-facet design deliver strong centring and chip control in suitable materials, while the uncoated bright finish performs best in non-ferrous or low-alloy applications where coating adhesion is not required.

Bright Finish Carbide Tool Fit

The straight flute geometry demands a rigid machine setup and constant feed to avoid chatter, making it unsuitable for hand-held or low-stiffness equipment. The solid carbide construction handles higher speeds than high-speed steel but requires coolant or air blast to clear chips from deep holes, freeing the operator from frequent peck cycles in appropriate materials.

Highlights

  • Solid carbide construction resists wear in abrasive materials
  • 140 degree point angle enables self-centering on hard surfaces
  • Straight flute design clears chips efficiently in shallow holes
  • 5/32 inch fractional size matches standard tooling requirements
  • Bright uncoated finish suits general-purpose machining tasks

Specifications

BrandCHICAGO-LATROBE
TypeCutting Tools

Questions about this item

Will this 140 degree point angle 5/32 in carbide drill work in a standard three-jaw chuck drill press?

Yes, the straight flute design and fractional inch shank fit standard three-jaw chucks on drill presses and hand drills.

How can I confirm the 140 degree point is cutting correctly after installation?

The four-facet point should produce clean holes with minimal burr at the 0.15625 decimal size when fed at proper carbide speeds.

Does the 78594 drill come with any coating or lubricant in the package?

The bright uncoated finish ships as a single drill bit; cutting fluid or lubricant must be purchased separately.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.