Cameron & Co
Cameron & Co DS-CS-BST504PW 3.6V 2Ah Li-ion battery
3.6 V 2 Ah Li-ion replacement battery for Bosch GSR Mx2Drive, PRODRIVE, PS10 and SPS10 models
- Direct replacement for Bosch GSR Mx2Drive and PRODRIVE tools
- 6 V 2000 mAh lithium-ion cell delivers 7.20 Wh runtime
- Compact 83.10 × 29.85 × 37.30 mm form fits original battery bay
- Matches OEM part numbers 2 607 336 241 and 2 607 336 242
- Brand-new Cameron Sino unit supplied as single black pack
Compatible Replacement Battery
The Cameron & Co DS-CS-BST504PW is a 3.6V 2Ah lithium-ion battery built to replace the original Bosch 36019A2010 pack. It fits GSR Mx2Drive, GSR PRODRIVE, PS10, SPS10 and SPS10-2 cordless tools. The black housing matches the OEM form factor for a direct swap.
Upgrade From Depleted Packs
This unit replaces Bosch part numbers 2 607 336 241, 2 607 336 242 and BAT504 when the original cells no longer hold a useful charge. The jump is worth it when runtime has fallen below the demands of a typical job or when the tool cuts out under load.
3.6V Platform Limits
The 3.6V architecture caps the energy reserve at 7.20 Wh, so extended high-drain tasks will require spare packs or frequent recharging. It cannot power tools designed for higher-voltage Bosch platforms, and the physical dimensions of 83.10 x 29.85 x 37.30 mm prevent use in larger battery bays.
Highlights
- Direct replacement for Bosch GSR Mx2Drive and PRODRIVE tools
- 6 V 2000 mAh lithium-ion cell delivers 7.20 Wh runtime
- Compact 83.10 × 29.85 × 37.30 mm form fits original battery bay
- Matches OEM part numbers 2 607 336 241 and 2 607 336 242
- Brand-new Cameron Sino unit supplied as single black pack
Specifications
| Brand | Cameron Sino |
|---|---|
| Model | DS-CS-BST504PW |
Questions about this item
Will the 83.10 x 29.85 x 37.30 mm case fit my Bosch GSR Mx2Drive?
Yes — the pack is built to the exact 83.10 x 29.85 x 37.30 mm footprint used by the Bosch GSR Mx2Drive, GSR PRODRIVE, PS10, SPS10 and SPS10-2 models.
How do I install the pack without damaging the contacts?
Slide the battery into the tool’s cavity until the latch clicks; forcing it at an angle bends the three gold contact pads on the 3.6 V 2000 mAh cell.
When should I replace the 2 Ah Li-ion cell?
Replace it once run-time drops below roughly 50 % of the original 7.20 Wh capacity or the pack no longer holds a charge after a full cycle.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



