We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Binks gravity spray gun transparent cup 1.4 mm nozzle 30 oz capacity

Binks

Binks 2466-14LV-23SG Gravity Sprayer 1.4 mm 30 oz

SKU CH-PN69-9Y2EE

Conventional gravity spray gun with 1.4 mm nozzle, 30 oz cup and 10.6 cfm air consumption for industrial and automotive coatings

  • ColorTransparent
  • Gravity feed delivers consistent material flow
  • 4 mm nozzle suits medium viscosity coatings
  • 30 oz cup reduces refill frequency
  • 6 cfm at 30 psi for efficient atomisation
  • Hardened stainless steel nozzle resists wear

Binks 1.4 mm Gravity Sprayer

The Binks 2466-14LV-23SG is a conventional spray gun designed for industrial and automotive coatings. It uses a gravity-feed fluid delivery system with a 1.4 mm hardened stainless steel nozzle. The 30 fl oz transparent cup holds a practical volume for medium-sized jobs. This tool suits painters who need a reliable gravity-fed applicator.

Air consumption and pattern control

Air consumption is rated at 10.6 cfm at 30 psi to produce a fan pattern between 8 in and 12 in wide. The fluid delivery speed is classified as medium for controlled material flow. The hardened stainless steel nozzle resists wear from abrasive coatings. These specifications determine the compressor capacity required for continuous operation.

Build integration and requirements

The gun connects via a standard 1/4 in air inlet fitting to a shop air supply. Gravity feed eliminates the need for a separate pressure pot or fluid hose. The medium delivery speed matches general-purpose topcoats and primers. Buyers who need higher fluid volume or a pressure-feed system should consider a different configuration.

Highlights

  • Gravity feed delivers consistent material flow
  • 4 mm nozzle suits medium viscosity coatings
  • 30 oz cup reduces refill frequency
  • 6 cfm at 30 psi for efficient atomisation
  • Hardened stainless steel nozzle resists wear

Specifications

BrandBINKS
ColorTransparent

Questions about this item

How do I attach the spray gun to my compressor and set the 10.6 cfm at 30 psi correctly?

Connect the 1/4 in air inlet to a regulated supply, set the regulator to 30 psi, then verify flow reaches 10.6 cfm; the step often missed is confirming both pressure and volume at the gun, not just at the compressor.

Which parts will wear first and need replacement with regular use?

The hardened stainless steel 1.4 mm fluid nozzle and needle assembly are the primary wear items; fluid passages and air-cap seals may also require periodic renewal.

At what point does the 30 fl oz cup capacity become the limiting factor during a continuous job?

The 30 fl oz gravity cup must be refilled once emptied; on large panels this refill interval arrives before air supply or nozzle wear limits output.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.