We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass ball valve with sweat connections and lever handle

Apollo

Apollo 94A20701 1-1/2" Sweat Brass Ball Valve

SKU CH-RS36-BWNX2

A two-piece brass ball valve with a full-port chrome-plated ball handles combustible gases at up to 600 psi operating pressure

  • Full-port design maximises flow efficiency
  • Chrome-plated brass ball resists corrosion and wear
  • Brass body rated for 600 psi operating pressure
  • Manual two-way operation simplifies on/off control
  • Sweat connection enables secure copper pipe installation

Apollo 94A20701 Sweat Brass Ball Valve

This two-way ball valve is built from brass with a chrome-plated brass ball and a full-port design. It suits installers and maintenance teams who need reliable shut-off for combustible gases in piping systems. The straight, two-piece body uses sweat connections for a permanent joint. Rated for 600 psi maximum operating pressure, it meets the demands of high-pressure lines.

Installation uses sweat fittings for a secure.

Sweat installation requires clean copper tubing, flux and a torch to form a solid joint. The full-port ball allows unrestricted flow once the valve is open. The non-locking handle gives quick quarter-turn operation without extra steps. Common issues include insufficient heating that leaves cold joints, or overheating that damages the seat seals. Ensure the valve is open while soldering to protect internal components from excess heat.

Verify pipe size and media compatibility before

Confirm the existing line is 1-1/2 inch copper tubing suitable for sweat joining. Check that the system pressure stays within the 600 psi rating and that the media is compatible with brass construction. The valve is not rated for steam service or vacuum duty. No 3-A sanitary rating applies, so it is not intended for food or pharmaceutical lines. Ensure local codes permit sweat brass valves for the planned combustible-gas application.

Highlights

  • Full-port design maximises flow efficiency
  • Chrome-plated brass ball resists corrosion and wear
  • Brass body rated for 600 psi operating pressure
  • Manual two-way operation simplifies on/off control
  • Sweat connection enables secure copper pipe installation

Specifications

BrandAPOLLO VALVES

Questions about this item

How can I verify the valve is working correctly after installation?

Confirm the handle operates smoothly through its full range and that no leakage occurs at the sweat connections when the system is pressurised up to 600 psi.

What comes with the valve and what must I supply?

The valve itself is supplied; you must provide copper tubing, solder, flux and a torch for the 1-1/2" sweat connections.

Which size should I select for a 1-1/2 inch copper line?

Choose the 94A20701 model, which is built for a nominal 1-1/2" sweat connection on a two-piece brass body.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.