We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Apollo 94A20601 1-1/4 inch sweat brass ball valve, straight two-piece body, chrome-plated ball, non-locking handle

Apollo

Apollo 94A20601 1-1/4" Sweat Brass Ball Valve

SKU CH-CFE7-6ZZG0

Two-piece brass ball valve with full-port chrome-plated ball rated to 600 psi for combustible gases

  • Full-port design allows unrestricted flow
  • Chrome-plated brass ball resists corrosion
  • Brass body handles 600 psi operating pressure
  • Two-piece construction simplifies inline maintenance
  • Non-locking handle enables quick manual operation

Apollo 94A20601 Brass Ball Valve

This Apollo 94A20601 valve is a manual two-way ball valve constructed from brass with a chrome-plated brass ball. It features a full-port design and a straight body style with sweat connections for 1-1/4 inch nominal piping. The valve carries a maximum operating pressure rating of 600 psi and is rated for use with combustible gases. A non-locking handle provides standard manual operation.

Installers needing sweat-end brass valve

This valve suits plumbers and HVAC technicians requiring a full-port brass ball valve for sweat installation on 1-1/4 inch lines carrying combustible gases at pressures up to 600 psi. It is not intended for applications demanding 3-A sanitary compliance or a rated steam pressure limit. Buyers who need a locking handle for security or a vacuum service rating should look at alternative valve models.

Sweat installation requires torch and flux

Installation uses standard copper sweat techniques: clean the pipe and valve ends, apply flux, assemble the joint, and heat evenly with a torch until solder flows into the cup. The valve must be in the open position during heating to prevent pressure build-up and seat damage. Overheating the brass body can degrade the PTFE seats, causing leaks, so heat control is critical. Ensure the system is depressurised and drained before starting work.

Highlights

  • Full-port design allows unrestricted flow
  • Chrome-plated brass ball resists corrosion
  • Brass body handles 600 psi operating pressure
  • Two-piece construction simplifies inline maintenance
  • Non-locking handle enables quick manual operation

Specifications

BrandAPOLLO VALVES

Questions about this item

What pipe size must I already have to sweat this 1-1/4 in Apollo ball valve in place?

You need 1-1/4 in copper tubing and a torch setup for sweat soldering; the valve body is straight-pattern brass with a full-port chrome-plated brass ball.

Can I keep my existing 600 psi rated copper lines when installing this valve?

Yes — the valve is rated for 600 psi maximum operating pressure, matching typical Type L or K copper systems used at that pressure class.

How do I confirm the valve is sealing properly after soldering and cooling?

Pressurise the line up to 600 psi with air or water; the two-piece brass body and full-port ball should hold pressure with zero leakage past the seats or stem.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.