We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Twelve copper braid spools in three widths 2.0 2.5 3.0 mm each 1.5 m long

12 Piece Solder Wick Set 1.5 m 2.0 2.5 3.0 mm

SKU CH-V2R0-6HB99

A 12-piece set of lead-free copper desoldering braid in 2.0 mm, 2.5 mm and 3.0 mm widths, each 1.5 m long, with low non-conductive residue for PCB rework

  • Standards/CertificationsLead Free Compliant
  • Low residue saves cleanup time with non-conductive, non-corrosive leftovers
  • Fine copper braid boosts capillary action for faster solder absorption
  • Three widths — 2.0 mm, 2.5 mm, 3.0 mm — cover varied joint sizes
  • 12 pieces at 1.5 m each provide ample length for repeated use
  • Safe on small PCBs for rework without damaging boards

12-Piece Solder Wick Set

This set contains 12 braided copper wicks for desoldering and rework tasks. Each piece measures 1.5 m in length. The pack includes four wicks each at 2.0 mm, 2.5 mm and 3.0 mm widths. The no-clean flux leaves minimal non-conductive, non-corrosive residue after use.

Upgrading from single-width spools

A mixed-width set replaces the need to buy separate spools for different joint sizes. The jump is worth it when you regularly work on both fine-pitch components and larger through-hole connections. The precise weave improves capillary action for faster solder absorption across all three widths.

Suits hobbyists and technicians doing PCB rework

The range of widths handles common component pitches found in consumer electronics and automotive modules. Builders who need very fine wick below 2.0 mm for dense SMD work or widths above 3.0 mm for heavy power joints should look at something else.

Highlights

  • Low residue saves cleanup time with non-conductive, non-corrosive leftovers
  • Fine copper braid boosts capillary action for faster solder absorption
  • Three widths — 2.0 mm, 2.5 mm, 3.0 mm — cover varied joint sizes
  • 12 pieces at 1.5 m each provide ample length for repeated use
  • Safe on small PCBs for rework without damaging boards

Specifications

Standards/CertificationsLead Free Compliant

Questions about this item

What widths of solder wick come in the 12-piece set?

The set includes four pieces each of 2.0 mm, 2.5 mm and 3.0 mm wide braid, giving three size options for different joint areas.

How do I use the braid without lifting pads on a small PCB?

Place the wick on the joint, press the hot iron tip on top and let capillary action draw the solder up; lift both together once saturated to avoid pulling copper tracks.

When should I replace a used length of wick?

Discard a section once it is fully saturated with solder and no longer draws fresh solder cleanly; each 1.5 m roll provides multiple fresh segments.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.