We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White sleeved PSU extension kit with 24-pin, EPS and PCIe cables plus combs

Vszerda

Vszerda PSU Cable Extension Kit 30cm White

SKU CH-TDXQ-QT6EY

White 30 cm extension kit adds 24-pin ATX, two EPS 4+4-pin and two PCIe 6+2-pin cables with combs for cleaner routing

  • Clean 30 cm extensions simplify cable routing
  • Triple-layer woven sleeves with soft silicone cover bend easily without spring-back
  • 18 AWG tinned copper cores carry stable current to all components
  • Male 5557 to female 5559 connectors fit standard ATX, EPS and PCI-E ports
  • Acrylic comb clips in three sizes keep every wire aligned and tidy

Extension Kit for ATX Builds

This kit supplies 30 cm extension cables for a standard ATX power supply. It contains one 24-pin motherboard cable, two 8-pin EPS cables and two 8-pin PCIe cables, all with male 5557 to female 5559 connectors. The set targets builders who want a cleaner look without replacing the original PSU cables.

Install With Included Combs

Each cable uses 18 AWG tinned copper cores wrapped in triple-layer woven sleeving that bends easily into shape. Four combs for the 24-pin, twelve for 8-pin and six for 6-pin sections keep wires aligned during routing. The 3.5 mm diameter fits most grommets, but tight bends behind small motherboard trays can still be awkward.

Steady Delivery Under Load

The 18 AWG conductors handle sustained current without the voltage drop seen on thinner extensions. Silicone insulation resists heat and does not emit odour during prolonged high-load sessions. Builders who need longer runs or higher amperage than 30 cm and 18 AWG provide should consider a full custom cable set instead.

Highlights

  • Clean 30 cm extensions simplify cable routing
  • Triple-layer woven sleeves with soft silicone cover bend easily without spring-back
  • 18 AWG tinned copper cores carry stable current to all components
  • Male 5557 to female 5559 connectors fit standard ATX, EPS and PCI-E ports
  • Acrylic comb clips in three sizes keep every wire aligned and tidy

Specifications

No published specifications for this item yet.

Questions about this item

How can I verify the 24-pin ATX and 8-pin EPS cables are delivering stable current after installation?

The kit uses 18 AWG pure copper tinned wire rated for stable overcurrent; check that all 24-pin and both 8-pin EPS connectors seat fully into the motherboard and that the system posts without voltage warnings.

What cables and combs are included and do I need to buy any extra connectors?

The box contains one 24-pin ATX, two 8-pin EPS 4+4, two 8-pin PCIe 6+2 cables plus four 24-pin combs, twelve 8-pin combs and six 6-pin combs — no extra connectors are required for a standard ATX build.

Which cable length should I choose for a typical mid-tower case?

Every cable in this kit is 30 cm long, a length suited to most mid-tower routing; if your PSU sits farther from the motherboard tray you may need longer extensions.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.