We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Internal SAS 4 SATA host cable with four SATA 7-pin connectors, 50cm length

Vszerda

Vszerda 4 SATA 7pin SAS 4 SATA Host to Cable 50cm

SKU CH-APHP-JJ5E2

Connects four SATA drives to a SAS host with 6 Gbps data transfer over 50 cm

Cable Length 50 cm

  • Connect four drives with one cable using 4 SATA 7-pin host connectors
  • 50cm length fits compact server and RAID chassis
  • Supports 6Gbps SAS specification for high-speed data transfer
  • Straight-through 7-pin to 7-pin wiring ensures reliable drive detection
  • SATA interface compatibility simplifies integration with existing controllers

4 SATA 7pin Host Cable

This 50cm internal cable connects four SATA drives to a 4 SATA host controller using 7-pin connectors on both ends. It is designed for server and RAID environments that require multiple drive connections from a single host port. The cable supports the 6Gbps SAS specification for reliable data transfer. Builders expanding internal storage arrays will find it a direct fit.

Upgrade From Single Drive Cables

Replacing individual SATA cables with this four-lane assembly reduces cable count and simplifies routing inside dense chassis. The jump is worth it when a controller or backplane presents a 4 SATA host interface and you need to attach four target drives without adding extra brackets or adapters. It eliminates the clutter of four separate runs while maintaining the same 6Gbps link speed per drive.

Straightforward Internal Routing

Installation consists of plugging the host connector into the controller and each device connector into a drive, with no drivers or configuration required. The fixed 50cm length suits typical server drive cages but can be tight in full-tower cases where the controller sits far from the drive bays. The only common issue is misaligning the 7-pin plugs, which are keyed to prevent reverse insertion but still need firm, straight pressure to seat fully.

Highlights

  • Connect four drives with one cable using 4 SATA 7-pin host connectors
  • 50cm length fits compact server and RAID chassis
  • Supports 6Gbps SAS specification for high-speed data transfer
  • Straight-through 7-pin to 7-pin wiring ensures reliable drive detection
  • SATA interface compatibility simplifies integration with existing controllers

Specifications

No published specifications for this item yet.

Other versions of this model

5 more in the same range

Same family, different memory, cooler or clock — compare before you commit.

Questions about this item

What host connector does the cable use to attach to the controller?

The host end uses four SATA 7-pin connectors that plug directly into a 4-port SATA or SAS controller.

How do I route the 50cm cable inside a server chassis without blocking airflow?

Run the cable along the drive cage brackets and secure it with the chassis cable-management clips so the 50cm length stays clear of fans and drive trays.

When should I replace the cable if I see intermittent drive errors?

Replace the cable if reseating both ends does not clear the errors, as the 7-pin SATA contacts can wear after repeated insertions.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.