We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
40 inch SATA III cable straight to right angle connector

SATAGear

SATAGear R-SS-1MSR 40in SATA III Straight to Right Angle Cable

SKU CH-KERZ-ZWNYA

Connects SATA drives to a controller at up to 6.0 Gbps with a straight-to-right-angle layout

  • Right-angle connector eases tight-case routing
  • 40-inch length spans full-tower drive bays
  • 0 Gbps throughput matches SATA III spec
  • Shielded cable blocks EMI and RFI noise
  • Narrow profile improves internal airflow

40-inch SATA III straight-to-right cable

This 40in internal cable connects a Serial ATA hard drive, optical drive or other SATA device to a motherboard or controller. The straight-to-right-angle layout lets the connector sit flat against the drive, which is useful in tight drive bays or behind stacked storage. Both ends carry 7-pin female connectors compliant with the SATA 1.0 specification.

Sustained 6.0 Gbps throughput

The cable is rated for data transfer rates up to 6.0 Gbps, so sequential reads and writes from modern SSDs or mechanical arrays run at the interface limit rather than being throttled by the link. Shielding protects the differential pairs from EMI and RFI, keeping error rates low during long backup or raid-rebuild sessions.

Narrow shielded build aids airflow

A slim, shielded jacket reduces bulk compared with legacy ribbon cables, leaving more room for air to move between drives and around the motherboard. The right-angle plug points downward, guiding the wire along the chassis floor instead of looping into the CPU cooler zone. Dual 7-pin female ends lock securely, so vibration from multiple spinning disks will not unseat the connection.

Highlights

  • Right-angle connector eases tight-case routing
  • 40-inch length spans full-tower drive bays
  • 0 Gbps throughput matches SATA III spec
  • Shielded cable blocks EMI and RFI noise
  • Narrow profile improves internal airflow

Specifications

ModelR-SS-1MSR

Questions about this item

Does the 40in R-SS-1MSR cable generate heat or noise during continuous operation?

The cable is a passive component with no moving parts or active electronics, so it produces no heat or noise regardless of how long it runs.

What existing hardware must I have to use this 40in SATA III straight-to-right-angle cable?

You need a Serial ATA controller or motherboard header with a standard 7-pin SATA port, plus a Serial ATA device such as a hard drive or optical drive that also has a 7-pin port.

Will this 40in cable work with an older motherboard that only supports the Serial ATA 1.0 specification?

Yes, the cable meets the Serial ATA 1.0 standard and will function with older controllers at their native speed.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.