We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small green circuit board with black components and silver pins

Ruth's sister

Ruth's sister 12V 24V 36V Mosfet Module internal power cable 22A

SKU CH-RCP5-SAPEJ

MOSFET module switches 12V, 24V or 36V loads up to 22A using 3V or 5V logic signals

  • Low-voltage MCU control switches high-power loads
  • Supports 3 V and 5 V logic inputs
  • Handles 12 V, 24 V and 36 V supply rails
  • Rated for 22 A continuous motor current

12V 24V 36V MOSFET Module for Arduino

This module switches loads up to 12V, 24V or 36V using a 3V or 5V logic signal from an Arduino or compatible MCU. It handles up to 22A of continuous current for motor speed control via PWM. The board isolates the low-voltage control side from the high-voltage power path. It suits hobbyists and engineers building custom motor drivers or power-switching circuits.

Upgrades from discrete transistor circuits

Replaces breadboarded MOSFETs and driver ICs with a single tested PCB that manages gate drive and heat. The jump is worth it when you need reliable 22A switching without designing your own gate-drive layout. It does not suit builders who need isolated high-side drive or voltages above 36V.

Highlights

  • Low-voltage MCU control switches high-power loads
  • Supports 3 V and 5 V logic inputs
  • Handles 12 V, 24 V and 36 V supply rails
  • Rated for 22 A continuous motor current

Specifications

No published specifications for this item yet.

Questions about this item

What voltage range can the module handle on the load side?

The module switches loads from 12 V up to 36 V with a maximum current of 22 A.

Which control voltage levels are required to drive the MOSFET gate?

Apply a logic signal between 3 V and 5 V to the control pin; the module then switches the high‑voltage load using PWM from an Arduino or MCU.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

More in Internal Power Cables

Similar items

Same shelf, same checkout — eight coins and a 30-minute rate lock.