We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A single rectangular 12 V 7 Ah sealed lead-acid battery in a plastic case

RefurbUPS

RefurbUPS EnerSys NP7-12 Compatible UPS Replacement Battery

SKU CH-7Y4G-3JKWP

A compatible replacement kit with one 12 V 7 Ah sealed lead-acid battery for UPS units

  • TypeKit/Package
  • Weight6
  • High-rate 12 V 7 A SLA cell delivers strong discharge performance
  • Factory-fresh battery ensures reliable UPS backup power
  • Single-unit kit simplifies replacement with included instructions
  • Genesis Series design built for consistent performance and longevity
  • Compatible replacement matches EnerSys NP7-12 specifications exactly

What this product is

This is a single 12 V 7 Ah sealed lead‑acid battery kit compatible with the EnerSys NP7‑12. It supplies a direct replacement for UPS units that require this specific cartridge. The pack arrives factory‑fresh and includes installation instructions for a straightforward swap.

Thermals noise and power

The sealed lead‑acid design operates silently and generates minimal heat during normal float or discharge cycles. No active cooling is required, so the battery adds no audible noise to the UPS enclosure. Power draw is limited to the self‑discharge characteristic of the chemistry.

The deciding specification

The critical figure is the 12 V 7 Ah rating; the UPS must be designed for exactly this voltage and capacity. If your unit calls for a different amp‑hour value or a different voltage, this cartridge will not be a correct fit. Buyers who need a higher capacity or a different form factor should look elsewhere.

Highlights

  • High-rate 12 V 7 A SLA cell delivers strong discharge performance
  • Factory-fresh battery ensures reliable UPS backup power
  • Single-unit kit simplifies replacement with included instructions
  • Genesis Series design built for consistent performance and longevity
  • Compatible replacement matches EnerSys NP7-12 specifications exactly

Specifications

Brandenersys
SeriesGenesis Series
TypeKit/Package
Weight6

Questions about this item

How do I install the 12 V 7 A SLA battery cartridge in my UPS?

Power off and unplug the UPS, open the battery compartment, disconnect the old cartridge noting polarity, connect the new cartridge matching red to positive and black to negative, secure it in the bay, close the cover, then power on and run a self-test.

What maintenance or replacement will the 12 V 7 A SLA battery need later?

The sealed lead-acid cell requires no watering; plan to replace the whole cartridge when runtime falls noticeably or the UPS reports a battery fault, typically after several years in standby service.

What limit appears first when the 12 V 7 A SLA battery runs under sustained discharge?

Voltage will drop toward the UPS low-battery cutoff, triggering shutdown once the cell reaches its end-of-discharge threshold.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.