We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
PrimoChill RFB finishing bit for 12mm by 16mm rigid tubing

PrimoChill

PrimoChill RFB Rigid Finishing Bit 12mm x 16mm DIY Cooling

SKU CH-0D2Q-TMH1X

A drill-bit finishing tool that reams, deburrs and trims 12mm x 16mm rigid tubing for custom watercooling loops

  • TypeCPU Block

Option 12mm ID X 16mm OD

  • Deburr and trim rigid tubing effortlessly using a standard drill
  • Achieve clean, smooth tube ends for a perfect loop fit
  • Scuff-free spinning thanks to sealed bearings on the bit
  • Adjust tube length precisely by varying drill RPM during finishing
  • Designed specifically for 12mm ID by 16mm OD PETG and PMMA tubing

Specialised tool for rigid tubing

The PrimoChill RFB Rigid Finishing Bit is a drill-mounted accessory built for custom watercooling loops. It reams, deburrs and trims hardline tubing in a single operation. The bit is sized for 12mm inner diameter and 16mm outer diameter rigid tube. Enthusiasts assembling PETG or PMMA loops will find it removes the need for hand reamers.

Sealed bearings and standard drill fit

Sealed bearings allow the bit to spin without scuffing the tube surface. The shank fits a standard drill chuck so no proprietary driver is required. At mid to low RPM it produces a smooth finish; at higher RPM it can trim the tube to final length. Rough cuts can therefore be fine-tuned after the initial saw cut.

Material limits and practice advice

The manufacturer advises against use with copper tubing because the bit dulls extremely quickly on that material. PETG and PMMA are the supported tube types. Users should practise on scrap pieces first to learn the material removal rate. No power or thermal figures apply to this hand-tool accessory.

Highlights

  • Deburr and trim rigid tubing effortlessly using a standard drill
  • Achieve clean, smooth tube ends for a perfect loop fit
  • Scuff-free spinning thanks to sealed bearings on the bit
  • Adjust tube length precisely by varying drill RPM during finishing
  • Designed specifically for 12mm ID by 16mm OD PETG and PMMA tubing

Specifications

TypeCPU Block

Other versions of this model

5 more in the same range

Same family, different memory, cooler or clock — compare before you commit.

Questions about this item

Which tubing dimensions does the 12mm x 16mm finishing bit support?

It is built for rigid tubing with a 12 mm inner diameter and a 16 mm outer diameter.

What type of drill chuck accepts the bit shank?

The bit uses a standard drill-bit shank that fits any common drill chuck.

How should the bit be run for the first few cuts to avoid removing too much material?

Start at mid to low RPM on scrap tube until you learn how quickly the bit removes material.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.