We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
PrimoChill RFB finishing bit for 10mm ID 12mm OD rigid tubing

PrimoChill

PrimoChill RFB Rigid Finishing Bit 10mm ID x 12mm OD

SKU CH-KD98-80CPV

Finishing bit reams, deburrs and trims 10mm ID x 12mm OD rigid tubing using a standard drill

  • TypeTubing

Option 10mm ID X 12mm OD

  • Ream, deburr and trim tubing effortlessly with a standard drill bit
  • Achieve clean, smooth tube ends for a perfect custom-loop fit
  • Designed for 10mm ID x 12mm OD rigid tubing sizes
  • Sealed bearings give scuff-free spinning during use
  • Rough-cut then fine-tune tube length at higher RPM for precision

Precision tooling for hardline loops

The PrimoChill RFB Rigid Finishing Bit is a drill-bit accessory made for 10mm ID by 12mm OD rigid tubing. It reams, deburrs and trims PETG or PMMA tube ends in a single operation, removing the need for hand reamers and giving a clean, square finish that seals reliably in compression fittings.

Suited to custom-loop builders who want repeatable

Enthusiasts assembling hardline watercooling loops will appreciate the speed and consistency this bit adds to tube preparation. It is not intended for copper tubing because the material dulls the cutting edges rapidly, and it does not suit soft tubing or any inner-diameter size other than the stated 10mm.

Steady performance under sustained use

Sealed bearings keep the bit spinning without scuffing the tube surface even during longer trimming sessions. Running at mid to low RPM produces smooth deburred ends, while higher RPM lets you fine-tune tube length quickly; the supplier advises practising on scrap pieces first to gauge material removal rate.

Highlights

  • Ream, deburr and trim tubing effortlessly with a standard drill bit
  • Achieve clean, smooth tube ends for a perfect custom-loop fit
  • Designed for 10mm ID x 12mm OD rigid tubing sizes
  • Sealed bearings give scuff-free spinning during use
  • Rough-cut then fine-tune tube length at higher RPM for precision

Specifications

TypeTubing

Other versions of this model

5 more in the same range

Same family, different memory, cooler or clock — compare before you commit.

Questions about this item

Does the 10 mm inner-diameter bit fit my existing standard drill?

Yes, the bit is designed to fit standard drills so you can use the drill you already own.

Will the finishing bit damage my 10 mm ID x 12 mm OD PETG or PMMA tubing if I keep using older copper tubing?

The bit is intended for PETG and PMMA only; copper tubing is not recommended because it dulls the cutting edges very quickly.

How can I confirm the bit is producing a clean, square end on the 12 mm outer-diameter tube after setup?

Run the drill at mid-to-low RPM and inspect the tube end — it should be smooth, free of burrs and perfectly square for a proper fitting seal.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.