We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Monoprice CPU 8 Pin Extension Cable 2-Pack 9.5-inch

SKU CH-W78S-TPTJQ

Two 9.5-inch CPU 8-pin extension cables extend PSU-to-motherboard power connections up to 400 W

  • TypeCable Connectors
  • ColorBlack
  • Length3 ft.
  • Connector Number1
  • Terminal GenderFemale to Female
  • SpecificationsTangle Free, 25 volts_of_direct_current, 8 Pin Atx, 8, 9.5,
  • Extends CPU power reach with 9.5-inch length
  • Two cables included for dual builds or spares
  • 18 AWG copper handles up to 400 W
  • Detachable 4+4 design fits 4-pin or 8-pin sockets
  • Self-adhesive tape supplied for tidy cable routing

CPU 8 Pin Extension Cable 2-Pack

This two-pack of Monoprice CPU 8 pin extension cables adds 9.5 inches of reach between a power supply and a motherboard. Each cable uses a male ATX 12V 8 pin (4+4) connector on one end and a female ATX 12V 8 pin connector on the other. The 18AWG tin-coated copper wire is rated for up to 400 W. A self-adhesive tape strip is included for cable management.

Builders extending CPU power to the motherboard

These cables suit anyone whose PSU CPU lead falls short of the motherboard socket in a large case or behind a tall cooler. They are not for connecting a graphics card; the supplier warns that using them for a GPU will cause damage. They also do not convert voltage or pin-outs, so they cannot adapt a PCIe 8 pin source to a CPU 8 pin destination.

400 W headroom on 18 AWG wire

The 1007-18AWG conductors comfortably handle typical desktop CPU power draws up to the 400 W rating. Headroom runs out if the system demands more than 400 W through the EPS connector, or if the 9.5 inch length still leaves a gap in an exceptionally large chassis.

Highlights

  • Extends CPU power reach with 9.5-inch length
  • Two cables included for dual builds or spares
  • 18 AWG copper handles up to 400 W
  • Detachable 4+4 design fits 4-pin or 8-pin sockets
  • Self-adhesive tape supplied for tidy cable routing

Specifications

BrandMonoprice
Model6.19317E+11
TypeCable Connectors
ColorBlack
Length3 ft.
Connector Number1
Terminal GenderFemale to Female
SpecificationsTangle Free, 25 volts_of_direct_current, 8 Pin Atx, 8, 9.5, inches, Black, 6.19317E+11
FeaturesTangle Free

Questions about this item

What power-supply connector must I already have to use this 9.5-inch CPU 8-pin extension?

Your power supply needs an ATX 12V 8-pin (4+4) male output; the cable’s male end plugs into that port and the female end reaches the motherboard.

Will the detachable 4+4 male end still fit an older motherboard that only has a 4-pin ATX CPU socket?

Yes — the 4-pin section slides off the 8-pin block, letting the cable connect to a legacy 4-pin motherboard header while the female end stays on the PSU side.

How can I confirm the 18 AWG wires are delivering power correctly after I route the two cables?

The system should POST and run stably under load; if the CPU receives clean 12 V the board will not report power errors or throttle unexpectedly.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.