We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A twelve foot cable with ten pin LEMO connectors at each end, black finish

iKan

iKan PD-12FTCBL 12 ft 10-pin LEMO printer cable

SKU CH-49KP-C3MYK MPN PD-12FTCBL

A 12 ft LEMO cable with 10-pin connectors on both ends for motor drive applications

  • TypeLEMO
  • Length12 ft.
  • Connector Detail1 x 10-pin LEMO 1 x LEMO
  • 12 ft length gives flexible placement on set
  • 10-pin LEMO connectors ensure secure motor-drive links
  • 20 oz weight keeps rig lightweight
  • LEMO cable type built for professional cinema gear
  • Data-transfer design supports reliable camera communication

12 ft 10-pin LEMO motor cable

The iKan PD-12FTCBL is a 12 ft extended motor drive cable built for PD Movie systems. It links compatible motor units to their controller using matching 10-pin LEMO connectors on both ends. The cable suits cinematographers and rental houses that need reliable data and power transmission over longer rig runs. It is not suited for setups that require a different pin count or a shorter fixed length.

Thermal noise and power behaviour

Passive copper construction means the cable generates no heat and adds no audible noise during operation. Power draw is determined entirely by the connected motor and controller rather than the cable itself. The 11.20 oz weight remains constant regardless of signal load. No active cooling or external power supply is involved.

Bundled accessories and software impact

The package contains only the single 12 ft LEMO-to-LEMO cable; no adapters, ferrules or configuration software are included. Users must verify that their motor and controller both accept 10-pin LEMO connections before installation. The cable itself does not alter motor calibration, firmware behaviour or protocol settings.

Highlights

  • 12 ft length gives flexible placement on set
  • 10-pin LEMO connectors ensure secure motor-drive links
  • 20 oz weight keeps rig lightweight
  • LEMO cable type built for professional cinema gear
  • Data-transfer design supports reliable camera communication

Specifications

Brandikan
TypeLEMO
Length12 ft.
Connector Detail1 x 10-pin LEMO 1 x LEMO

Questions about this item

How do I connect the 10-pin LEMO ends without bending the pins?

Align the red dot on each 10-pin LEMO connector with the matching slot, push straight in until the collar clicks, then tighten the knurled ring by hand — forcing it at an angle bends the delicate pins.

What part of the 12 ft LEMO cable wears out first with repeated mating cycles?

The spring-loaded contacts inside each 10-pin LEMO connector lose tension after hundreds of insertions, causing intermittent signal; the cable jacket and conductors typically outlast the connectors.

At what length does voltage drop become noticeable on this 12 ft 10-pin LEMO motor drive cable?

The 12 ft length keeps resistance low enough that voltage drop only appears under sustained maximum motor current; shorter runs would not show the effect.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.