We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black 90-degree IEC C13 to C14 power cable, 40 cm

Enfain

Enfain 90° C13 to C14 40 cm computer power cord

SKU CH-CN76-Y2RFF

A 40 cm IEC C13 to C14 extension cord with a 90-degree elbow for tight rear-panel or rack clearances, rated 10 A 250 V

Style Up Angle

  • 90° angled connectors fit tight rear-panel spaces
  • 40 cm length keeps cable runs short and tidy
  • IEC C14 male to C13 female extends existing power leads
  • Rated 10 A at 250 V for standard desktop and peripheral loads
  • Suits computers, monitors, printers, projectors and PDU or UPS ports

90° C13 to C14 40 cm power cord

This 40 cm extension cable connects a C14 male inlet to a C13 female outlet using a 90° upward elbow. It is built for desktop computers, monitors, printers, projectors and similar devices that use standard IEC320 connectors. The short length and right-angle design help route power in tight spaces behind equipment or inside rack cabinets. Rated for 10 A at 250 V.

Check connector orientation and clearance

Verify that the device you are powering has a C14 inlet and that the power source provides a C13 outlet, such as a PDU or UPS. The upward 90° bend points the cable away from the inlet, so confirm there is enough vertical room for the elbow without stressing the port. Ensure the equipment operates at the supplied voltage to avoid damage.

Behaviour under continuous load

The cable uses 0.75 mm² conductors rated for a steady 10 A at 250 V, so it carries full rated current without overheating during prolonged use. The moulded IEC320 C14 and C13 ends maintain secure contact in rack environments where vibration can loosen straight plugs. No active cooling or derating is required for continuous operation within the rated limits.

Highlights

  • 90° angled connectors fit tight rear-panel spaces
  • 40 cm length keeps cable runs short and tidy
  • IEC C14 male to C13 female extends existing power leads
  • Rated 10 A at 250 V for standard desktop and peripheral loads
  • Suits computers, monitors, printers, projectors and PDU or UPS ports

Specifications

No published specifications for this item yet.

Other versions of this model

3 more in the same range

Same family, different memory, cooler or clock — compare before you commit.

Questions about this item

Does the 40 cm Enfain cord ship with any extra hardware, or is it just the IEC C14-to-C13 cable?

Only the 40 cm IEC C14 male to IEC C13 female cord is included; no additional brackets, screws or adapters are supplied.

The listing mentions 10 A 250 V and 0.75 mm² conductors — which of those figures should guide my choice?

Both matter: the 10 A 250 V rating sets the maximum load, while the 0.75 mm² cross-section supports that current over the short 40 cm run.

Will the 90 ° upward elbow on the C13 end actually save space behind a rack-mounted PDU?

Yes — the 90 ° bend points the cable upward, letting the connector sit flush against the PDU’s C13 outlet and reducing rear-profile depth in tight cabinets.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.