We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Jet-black pre-sleeved Y-splitter cable with six 3-pin fan connectors, 50 cm long

Darkside Computer Modding

Darkside Computer Modding 3-Pin Triple Push-Pull Radiator Fan Power Y-Cable Splitter Jet Black 50cm

SKU CH-PFR9-4VK63

Connects six 3-pin fans in push-pull on dual radiators to a single 3-pin power source, pre-sleeved and 50 cm long

  • Cable Length1.6 ft.
  • Connects six 3-pin fans in push-pull on dual radiators to one 3-pin header
  • Pre-sleeved cable keeps wiring tidy inside triple-radiator builds
  • 50 cm length spans large cases without excess slack
  • Single power source simplifies fan-controller management
  • Total fan wattage must stay within the power source rating

Push-Pull Radiator Fan Splitter

This 3-pin Y-cable connects six fans in a push-pull arrangement on dual radiators to a single power source such as a fan controller. It is built for custom liquid-cooling loops that use triple radiators and need tidy power distribution.

Pre-Sleeved 50 cm Cable

The assembly measures approximately 50 cm in total length and comes pre-sleeved for a clean look inside the case. Each branch plugs directly into 3-pin fan headers, so installation follows standard routing paths without adapters.

Wattage Limit Awareness

Users must ensure the combined draw of all six fans stays within the rating of the chosen power source. The splitter itself adds no active regulation, so thermal and acoustic results depend entirely on the attached fans and controller settings.

Highlights

  • Connects six 3-pin fans in push-pull on dual radiators to one 3-pin header
  • Pre-sleeved cable keeps wiring tidy inside triple-radiator builds
  • 50 cm length spans large cases without excess slack
  • Single power source simplifies fan-controller management
  • Total fan wattage must stay within the power source rating

Specifications

Cable Length1.6 ft.

Questions about this item

What does the 3-pin connector limit on this splitter?

The 3-pin connector provides power and tachometer signal only, so fan speed is controlled by voltage regulation rather than PWM duty cycles.

What clearance does the 50 cm cable need inside a triple-radiator build?

The 50 cm pre-sleeved cable is optimised for triple radiators and requires enough routing space to reach six fans in a push-pull layout without tension.

How do you install the splitter without overloading the header?

Connect all six 3-pin fans to the splitter, plug the single 3-pin lead into the fan controller, then verify the combined fan wattage stays within the header’s rated limit.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.