We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Gray frameless VGA cooling fan with four-pin connector

Zyvpee

Zyvpee T128010SU VGA Cooling 12V .35A 4 Pin Frameless

SKU CH-RZ9K-F7Q73

Frameless VGA cooler runs on 12V .35A through a 4-pin connector and uses a sleeve bearing for graphics card cooling

  • TypeCPU Cooler Fan
  • Bearing Typesleeve
  • Power Connector4 Pin
  • ColorGray
  • LEDNon-LED
  • Featuresvga fan
  • Frameless design fits tight GPU spaces
  • 12 V .35 A power draw keeps energy use low
  • Four-pin connector enables precise PWM speed control
  • Sleeve bearing provides quiet operation for video cards
  • Grey non-LED finish suits understated builds

Frameless 12V 4-pin VGA cooler

The Zyvpee T128010SU is a frameless fan built for video-card cooling. It targets builders replacing a worn GPU fan or assembling a custom graphics cooler. The 4-pin connector supports PWM speed control on compatible headers. Buyers who need a framed housing or integrated heatsink should look elsewhere.

Sleeve bearing thermals and acoustics

A sleeve bearing keeps running noise low during typical loads. The motor draws 0.35 A at 12 V, equating to modest power consumption. Speed scales with the PWM signal so the fan stays quiet at idle and ramps up only when the GPU demands it. No RGB lighting means no extra electrical load.

Grey frameless build and connectivity

The grey frameless body fits tight clearances around GPU heatsinks where square frames cannot. Four wires terminate in a standard 4-pin plug for direct motherboard or graphics-card connection. Sleeve bearings require occasional lubrication for long life. Installers must verify mounting-hole alignment before purchase.

Highlights

  • Frameless design fits tight GPU spaces
  • 12 V .35 A power draw keeps energy use low
  • Four-pin connector enables precise PWM speed control
  • Sleeve bearing provides quiet operation for video cards
  • Grey non-LED finish suits understated builds

Specifications

BrandZyvpee
SeriesT128010SU
ModelT128010SU
TypeCPU Cooler Fan
Bearing Typesleeve
Power Connector4 Pin
ColorGray
LEDNon-LED
Featuresvga fan

Questions about this item

How do I install the T128010SU frameless cooler on my graphics card?

Mount the frameless T128010SU using its existing screw holes, connect the 4-pin power connector to the GPU fan header, and ensure the sleeve-bearing fan spins freely before final tightening.

What maintenance will the T128010SU sleeve-bearing fan need over time?

The sleeve bearing may require occasional light lubrication or full fan replacement if noise increases, as it lacks the longer-life ball-bearing design.

At what power draw does the T128010SU hit its cooling limit under sustained load?

The 12 V, .35 A rating caps the fan at roughly 4 watts, so prolonged high-heat loads beyond that airflow capacity will raise GPU temperatures first.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.