We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Zyvpee

Zyvpee NIDEC 4210 TA150DC C34247-16 CQ 5V 0.13A 2-Wire 42x10mm Case Fan

SKU CH-NSD3-QAVSS

Compact 42×10 mm ball-bearing case fan runs on 5 V at 0.13 A with a two-wire connector

  • TypeCase Fan
  • Bearing TypeBall
  • Power Connector2 Wires
  • ColorBlack
  • LEDNon-LED
  • Features4CM Case Fan
  • Compact 42 mm frame fits tight chassis spaces
  • Ball bearing ensures durable, low-friction rotation
  • 5 V 0.13 A draw keeps power load minimal
  • Two-wire connector simplifies motherboard installation
  • Non-LED black design maintains a clean, stealthy look

Zyvpee NIDEC 4210 42x10mm Case Fan

This 42 by 10 millimetre case fan uses a ball bearing and runs on a two-wire five volt connection drawing zero point one three amps. It is built for tight spaces where a standard square frame will not fit. The black non-LED housing keeps the look neutral inside any chassis.

Upgrade from larger or sleeve-bearing fans

Builders replacing a noisy sleeve-bearing unit or a thicker frame that blocks nearby components will notice the thinner profile and longer bearing life. The jump is worth it when clearance is measured in millimetres and a 42 by 10 footprint is the maximum the layout allows.

Check voltage header and mounting holes

Verify the board or controller supplies a five volt two-pin header rated for at least zero point one three amps. Confirm the chassis has 42 millimetre hole spacing or a compatible bracket before ordering.

Highlights

  • Compact 42 mm frame fits tight chassis spaces
  • Ball bearing ensures durable, low-friction rotation
  • 5 V 0.13 A draw keeps power load minimal
  • Two-wire connector simplifies motherboard installation
  • Non-LED black design maintains a clean, stealthy look

Specifications

BrandZyvpee
SeriesC34247-16
ModelC34247-16
TypeCase Fan
Bearing TypeBall
Power Connector2 Wires
ColorBlack
LEDNon-LED
Features4CM Case Fan
Dimensions42*10mm

Questions about this item

Will the 42 mm by 10 mm frame line up with the mounting holes on my board?

The fan measures 42 mm by 10 mm; verify your board's hole spacing against those dimensions before fitting.

How do I connect the two-wire lead without reversing polarity?

The red wire carries 5 V at 0.13 A and the black wire is ground; match them to the header's markings before powering on.

When should I plan to replace the ball-bearing fan?

Ball bearings typically run for tens of thousands of hours; replace the unit if noise increases or airflow drops noticeably.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.