Zyvpee
Zyvpee MMF-06G24ES RM1 60*25mm 24VDC .1A 3 Pin case fan
A 60 mm DC axial case fan with ball bearing, 24 VDC, 0.1 A draw and a 3-pin connector
- TypeCase Fan
- Bearing TypeBall
- Power Connector3 Pin
- ColorBlack
- LEDNon-LED
- FeaturesDC axial fan
- 60 mm compact frame fits tight chassis
- Ball bearing design extends operating life
- 24 VDC 0.1 A draw keeps power use low
- Three-pin connector enables speed monitoring
- Non-LED black finish suits subtle builds
60 mm 24 VDC axial fan for inverter cooling
The Zyvpee MMF-06G24ES RM1 is a 60 by 25 millimetre DC axial fan designed for inverter cooling and general case airflow. It runs on 24 VDC at 0.1 A and uses a three-pin power connector. The black frame houses a ball bearing and carries no LED lighting.
Ball bearing and three-pin connector
A ball bearing supports continuous operation in tight chassis spaces where sleeve bearings might wear faster. The three-pin header delivers power and a tachometer signal to the motherboard or fan controller, allowing speed monitoring without PWM control. Non-LED black blades keep the visual profile neutral in any build.
Replaces noisy or failed 60 mm case fans in 24 V
This unit suits repair or upgrade work on equipment that specifies a 24 VDC 60 mm frame, such as industrial inverters or compact servers. It is not for builders who need PWM speed curves, 12 V operation, larger frame sizes, or addressable lighting.
Highlights
- 60 mm compact frame fits tight chassis
- Ball bearing design extends operating life
- 24 VDC 0.1 A draw keeps power use low
- Three-pin connector enables speed monitoring
- Non-LED black finish suits subtle builds
Specifications
| Brand | Zyvpee |
|---|---|
| Series | MMF-06G24ES RM1 |
| Model | MMF-06G24ES RM1 |
| Type | Case Fan |
| Bearing Type | Ball |
| Power Connector | 3 Pin |
| Color | Black |
| LED | Non-LED |
| Features | DC axial fan |
| Dimensions | 60*25mm |
Questions about this item
What voltage does the 3-pin connector on this 60mm fan require?
The fan runs on 24VDC and draws .1A through its three-pin power connector.
Will the 60 by 25mm frame fit my chassis mounting holes?
The square frame measures 60mm per side and is 25mm thick, matching standard 60mm fan mounting patterns.
How do I connect the three wires without reversing polarity?
Match the three wires to the motherboard header — typically red to 24V, black to ground, and the third wire to the tachometer pin — and verify orientation before powering on.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00114223BTC
In stock
