Zyvpee
Zyvpee GB1205AFV2-A 50x10mm 12V 1.1W 3-wire magnetic blower
A 50 mm magnetic-bearing blower fan drawing 1.1 W at 12 V with a 3-wire connector
- TypeBlower
- Bearing TypeMagnetic Barometric
- Power Connector3 wires
- Color2-Tone
- LEDNon-LED
- FeaturesDC Blower
- 12 V blower fits 50 mm notebook bays
- 1 W draw keeps system power low
- Magnetic barometric bearing runs quietly
- 3-wire connector enables speed monitoring
- Compact 50 x 10 mm frame saves space
Compact 12 V blower for tight spaces
This 50 mm square blower draws 1.1 W from a 12 V supply and fits into 10 mm thin cavities. The magnetic barometric bearing reduces friction in a small footprint. It targets notebook repairs and small-form-factor chassis where axial fans cannot mount.
3-wire power connector confirms speed control
The three-wire lead provides a tachometer signal so the host can monitor rotor speed. Voltage regulation or PWM is handled by the mainboard header; the blower itself has no onboard controller. Verify that your board offers a 3-pin 12 V header before ordering.
Mounts in 50 × 50 mm cut-outs with 10 mm clearance
Four corner holes accept standard M3 screws for direct chassis attachment. The blower exhausts perpendicular to the intake plane, moving air across heatsinks or VRM zones. No LED lighting keeps the unit suitable for dark chassis interiors.
Highlights
- 12 V blower fits 50 mm notebook bays
- 1 W draw keeps system power low
- Magnetic barometric bearing runs quietly
- 3-wire connector enables speed monitoring
- Compact 50 x 10 mm frame saves space
Specifications
| Series | GB1205AFV2-A |
|---|---|
| Model | GB1205AFV2-A |
| Type | Blower |
| Bearing Type | Magnetic Barometric |
| Power Connector | 3 wires |
| Color | 2-Tone |
| LED | Non-LED |
| Features | DC Blower |
| Dimensions | 50*50*10mm |
Questions about this item
What does the 1.1 W power draw mean for a notebook blower?
The blower draws 1.1 W at 12 V, so it adds minimal load to a laptop’s cooling circuit while still moving air through tight heatsink channels.
How does the 3-wire connector affect speed control?
The three wires provide power, ground and a tachometer signal, allowing the system to monitor blower speed but not to vary it via PWM.
Will the 50 mm square by 10 mm thick frame fit my notebook’s fan slot?
The blower measures 50 mm × 50 mm × 10 mm, matching the standard 5 cm slim profile used in many notebook cooling assemblies.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



