Zyvpee
Zyvpee DSB0812H 80mm 8025 12V 0.21A 2 Pin case fan
An 80 mm ball-bearing case fan with a 2-pin connector running at 12 V and 0.21 A
- TypeCase Fan
- Bearing TypeBall
- Power Connector2 Pin
- ColorBlack
- LEDNon-LED
- Dimensions80*25mm
- 80 mm frame fits tight chassis spaces
- 25 mm thickness matches standard 8025 mounting holes
- Ball bearing reduces friction for longer service life
- 12 V 0.21 A draw keeps power load low
- Two-pin connector plugs directly into legacy headers
80mm 2-pin case fan
The Zyvpee DSB0812H is an 80 by 25 millimetre case fan built for standard 12 volt DC power. Its two-wire connector suits older motherboard headers or direct molex adapters without PWM control. The ball bearing design targets continuous operation in compact chassis or CPU cooler stacks. Builders needing variable speed curves or RGB lighting should look elsewhere.
Ball bearing thermals and power
The fan draws 0.21 amps at 12 volts, yielding a low nominal power draw for auxiliary airflow duties. Ball bearing construction reduces friction compared to sleeve alternatives, helping maintain consistent rotational speed over long duty cycles. Acoustic output stays proportional to the fixed voltage supply since no speed modulation is present. Installers should verify header current limits before daisy-chaining multiple units.
Two-wire simplicity and mounting
The bundle consists solely of the fan frame with pre-drilled corner holes matching the 80 millimetre pattern. No screws, adapters, fan-speed controllers or software utilities are included in the package. The bare two-wire lead requires a compatible header or a separate 4-pin to 2-pin adapter for modern boards. Buyers planning multi-fan arrays must source splitters or hubs independently.
Highlights
- 80 mm frame fits tight chassis spaces
- 25 mm thickness matches standard 8025 mounting holes
- Ball bearing reduces friction for longer service life
- 12 V 0.21 A draw keeps power load low
- Two-pin connector plugs directly into legacy headers
Specifications
| Brand | Zyvpee |
|---|---|
| Series | DSB0812H |
| Model | DSB0812H |
| Type | Case Fan |
| Bearing Type | Ball |
| Power Connector | 2 Pin |
| Color | Black |
| LED | Non-LED |
| Dimensions | 80*25mm |
Questions about this item
How do I install the 2 Pin 12V connector on this 80mm fan?
Align the two pins with the motherboard header or fan controller, press firmly until seated, and route the wires so the 80*25mm frame clears adjacent components.
When will the ball bearing in the DSB0812H need replacement?
Ball bearings typically run for years; replace the fan when noise increases or RPM drops noticeably under constant 12V 0.21A operation.
At what point does the 8025 frame size limit airflow in a tight chassis?
The 80*25mm dimensions restrict clearance in slim cases; verify 80mm mounting holes and 25mm depth before sustained 12V use.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00115349BTC
In stock
