YEPLOOK
YEPLOOK PCIe 8Pin 6+2Pin Sleeved 60cm Cable for Corsair HX Type 4
A 60 cm sleeved PCIe cable with a modular 8-pin PSU connector and a 6+2-pin GPU plug, built from 18 AWG tinned copper for Corsair HX Type 4 power supplies
- ColorBlack
- Cable Length1.96 ft. (0.60m)
- Tinned copper wire resists oxidation for longer cable life
- Nylon braided sleeve allows tight bends and clean routing
- 60 cm length fits compact builds without excess slack
- 6+2 pin design works with 6-pin or 8-pin GPU sockets
- Rated for up to 800 W with modern graphics cards
What this cable is and who it fits
This is a YEPLOOK PCIe 6+2Pin power cable built for Corsair HX Platinum Type 4 modular supplies including the HX750, HX850, HX1000 and HX1200. It connects a PSU 8Pin port to a graphics card 8Pin or 6Pin socket using UL1007 18AWG tinned copper wire wrapped in a nylon braided net. The 60cm length suits standard tower builds.
Who should use it and who should not
Builders replacing or extending a GPU power lead on the listed Corsair HX Platinum Type 4 units will find the correct pin layout and 800W rating. It is not for any other power supply brand or Corsair series; mixing cables can cause damage. Buyers with non-Type 4 modular PSUs must look elsewhere.
The spec that decides compatibility
The cable carries a PSU-side 8Pin connector with one empty pin position, which is the standard Type 4 pinout, and a GPU-side 6+2Pin plug that slides to fit either 6Pin or 8Pin graphics card sockets. Verify this exact pin arrangement against your original cable before installing.
Highlights
- Tinned copper wire resists oxidation for longer cable life
- Nylon braided sleeve allows tight bends and clean routing
- 60 cm length fits compact builds without excess slack
- 6+2 pin design works with 6-pin or 8-pin GPU sockets
- Rated for up to 800 W with modern graphics cards
Specifications
| Brand | YEPLOOK |
|---|---|
| Color | Black |
| Cable Length | 1.96 ft. (0.60m) |
Questions about this item
How do I install this PCIe 6+2 pin cable into my Corsair HX Type 4 PSU and avoid the common pin-layout mistake?
Connect the PSU-side 8-pin plug into a Corsair HX Type 4 modular port; one pin position is intentionally empty — this is the default design, not a defect. Then slide the 2-pin section on or off the GPU-side connector to match your card's 6-pin or 8-pin socket.
What maintenance or replacement will this 60 cm sleeved cable need over time?
The 18 AWG tinned copper conductors and nylon braid resist heat and ageing; no routine maintenance is required. Replace the cable only if the sleeving frays, a connector becomes loose, or you move to a non-Corsair Type 4 power supply.
What is the first limit I will hit when running a high-end GPU continuously on this 60 cm cable?
The cable is rated for up to 800 W power delivery; sustained loads above that level will exceed the 18 AWG conductor's safe capacity before temperature or length becomes an issue.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



