We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

YEPLOOK

YEPLOOK 6Pin to 3x Molex 18AWG 50+15+15cm internal power cable

SKU CH-QF6Z-9V48P

Connects Corsair Type 3 and 4 modular PSUs to three Molex devices using 18AWG wire with 50cm, 15cm and 15cm branches

  • ColorBlack
  • Powers three Molex devices from one Corsair 6-pin port
  • 18AWG UL1007 tinned copper wire resists heat and aging
  • 50 cm main lead plus two 15 cm branches aid cable routing
  • Flexible sheath simplifies bends and keeps builds tidy
  • Compatible with Corsair Type 3 and Type 4 modular PSUs

6-Pin to Triple Molex Cable for Corsair PSUs

This internal power cable converts a single 6-pin modular output on compatible Corsair supplies into three Molex 4-pin connectors. It supports older peripherals such as floppy drives, optical drives, case fans and motherboard headers. The cable is built with 18AWG UL1007 tinned copper wire rated for heat resistance and long-term durability.

50 cm Main Lead with Two 15 cm Branches

The 50 cm primary run reaches from the PSU to the drive bay area, while two 15 cm tails fan out to individual devices. Flexible insulation makes routing simple and keeps cable management tidy. Two unused pins on the 6-pin plug are normal for this pin-out and do not indicate a defect.

Check PSU Compatibility Before Ordering

This cable works only with Corsair Type 3 and Type 4 modular units listed in the specifications, including HX650, HX750, HX850, HX1050, RM series up to 1000 W, CX-M series and AXi/HXi models. It will not function with Corsair Type 1 or Type 2 supplies or any non-Corsair brand. Verify your exact PSU model against the supported list before purchasing.

Highlights

  • Powers three Molex devices from one Corsair 6-pin port
  • 18AWG UL1007 tinned copper wire resists heat and aging
  • 50 cm main lead plus two 15 cm branches aid cable routing
  • Flexible sheath simplifies bends and keeps builds tidy
  • Compatible with Corsair Type 3 and Type 4 modular PSUs

Specifications

ColorBlack

Questions about this item

Will the 18AWG UL1007 tinned copper wires or Molex connectors need replacement after extended use?

The 18AWG UL1007 tinned copper wire is heat resistant and designed to resist aging, so the cable itself does not require scheduled replacement under normal conditions.

What is the first limit reached when powering three Molex devices continuously from the single 6‑pin source?

The total current draw of all connected fans, drives or peripherals must stay within the 6‑pin connector and PSU rail rating; exceeding that limit will trigger protection before the cable itself becomes a bottleneck.

Does the cable add noticeable heat or noise when the system runs all day?

The cable is passive with no moving parts, so it produces no noise; its 18AWG conductors run cool under typical loads, adding negligible heat inside the case.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.