We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat grey Cat6 patch cable with left-angled RJ45 plug to straight plug, 50cm long

xiwai

xiwai Left Angled Cat6 STP Ethernet Cable 50cm 90 Degree

SKU CH-J3DK-NDK3Y

A 50 cm shielded Cat6 patch cord with a 90-degree left-angled plug on one end and a straight plug on the other for tight port clearances

  • 90-degree angled plug routes cable neatly in tight spaces
  • STP shielding protects signal integrity against electromagnetic interference
  • Cat6 specification supports gigabit Ethernet speeds up to 1 Gbps
  • 50 cm length keeps short runs tidy without excess slack
  • RJ45 male-to-male connectors fit any standard Ethernet port

Left Angled Cat6 Patch Cord 50 cm

This xiwai cable is a shielded Cat6 patch cord with an 8P8C RJ45 male connector on each end. One end bends 90 degrees to the left, the other remains straight, and the overall length is 50 cm. It is built for any standard Ethernet connection.

Builders needing a tight side exit versus straight

The left-angled plug suits installations where the port sits close to a wall or panel and the cable must turn immediately. Installations that require a right-angled turn, a straight boot on both ends, or a longer reach should choose a different cable.

90 degree left-angled connector

The single specification that decides fit is the 90 degree left-angled plug orientation. Verify that the device port and surrounding clearance match a left-hand bend before ordering.

Highlights

  • 90-degree angled plug routes cable neatly in tight spaces
  • STP shielding protects signal integrity against electromagnetic interference
  • Cat6 specification supports gigabit Ethernet speeds up to 1 Gbps
  • 50 cm length keeps short runs tidy without excess slack
  • RJ45 male-to-male connectors fit any standard Ethernet port

Specifications

No published specifications for this item yet.

Questions about this item

Will the 90 degree left-angled plug fit beside other cables on my existing router ports?

The 90 degree left-angled plug directs the cable to the side, reducing protrusion and helping it sit flush alongside other connections on crowded router or switch ports.

How can I confirm the Cat6 STP shielding is functioning after I connect it?

Verify a stable link light at both ends and run a speed test; Cat6 STP supports gigabit rates, so consistent throughput near your plan maximum indicates the shielding and contacts are working.

Does the 50cm cable include both the straight and angled RJ45 connectors, or do I need separate adapters?

The 50cm patch cord comes with a straight 8P8C RJ45 male on one end and a 90 degree left-angled 8P8C RJ45 male on the other, both shielded, so no extra adapters are required.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.