We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
WMtec DB44 male-to-female extension cable, 44-pin, 1.5 m

WMtec

WMtec DB44 male to female extension cable 44-pin 1.5m

SKU CH-DYT4-NGS3C

Pure copper 44-pin DB44 male-to-female extension cable carries CNC programmer signals over 1.5 m

  • Pure copper conductors ensure reliable signal transmission
  • Male-to-female DB44 extension adds 1.5 m reach for CNC programmers
  • 3-row 44-pin layout matches standard industrial connectors
  • New condition guarantees full performance out of the box

DB44 extension cable for CNC equipment

This 44-pin male-to-female cable extends the connection between a CNC programmer and its controller. Pure copper conductors carry signals over a 1.5 m run without adding bulk to the workstation. The three-row DB44 layout matches legacy industrial interfaces exactly. It suits technicians who need a longer reach on existing wiring looms.

Replaces shorter or damaged DB44 leads

Use it when the original cable is too short for a revised machine layout or when a worn lead causes intermittent faults. The extension avoids rewiring the whole panel and keeps the same pin-out. It is not for users who need a different pin count, a fibre-optic link or a ruggedised outdoor rating.

Highlights

  • Pure copper conductors ensure reliable signal transmission
  • Male-to-female DB44 extension adds 1.5 m reach for CNC programmers
  • 3-row 44-pin layout matches standard industrial connectors
  • New condition guarantees full performance out of the box

Specifications

No published specifications for this item yet.

Questions about this item

What connector spacing does the DB44 male end need on the equipment panel?

The cable uses a standard 3-row 44-pin DB44 male connector that matches the common D-sub panel cut-out for this pin count.

Which orientation should the male plug face when inserting it into a CNC programmer port?

Align the wide row of the 3-row 44-pin male connector with the wide row of the female port, then press straight in until the screws engage.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.