We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Wilson 952310 ultra low loss coaxial cable 10 ft with N-Male connectors

Wilson Electronics, Inc.

Wilson Electronics, Inc. 952310 Ultra Low Loss Coaxial RF Cable 10 ft

SKU CH-BWC7-NMW5M

Ultra-low-loss coaxial cable with N-male connectors, 10 ft long, attenuates signal under 1 dB for indoor or outdoor amplifier links

  • TypeAntenna Cable
  • ColorMulticolor
  • Length10 ft.
  • Connector Detail1 x N-Type Male Antenna
  • Ultra-low signal loss under 1 dB preserves amplifier output
  • N-Male connectors on both ends fit Wilson in-building amps directly
  • Ten-foot length links amp to splitter, tap or antenna
  • Suitable for indoor and outdoor installations
  • Multicolour jacket aids cable identification in complex runs

Wilson 952310 Ultra Low Loss Coaxial Cable

This 10 ft coaxial cable carries RF signals between a Wilson in-building amplifier and a splitter, tap or antenna with minimal loss. It uses N-Male connectors on both ends and is rated for indoor or outdoor installation. The cable suits installers who need a short, low-attenuation link in a cellular booster system.

Installers building a Wilson booster system

The cable fits any Wilson amplifier equipped with N-connectors and works for indoor or outdoor antenna runs. Buyers who need a different connector type, a longer run or a cable for a non-Wilson system should look elsewhere.

Signal loss under 1 dB at 10 ft

Attenuation stays below 1 dB across the 10 ft length, preserving signal strength between the amplifier and the antenna or splitter. This single figure determines whether the cable meets the link budget for the installation.

Highlights

  • Ultra-low signal loss under 1 dB preserves amplifier output
  • N-Male connectors on both ends fit Wilson in-building amps directly
  • Ten-foot length links amp to splitter, tap or antenna
  • Suitable for indoor and outdoor installations
  • Multicolour jacket aids cable identification in complex runs

Specifications

BrandWilson Jones
TypeAntenna Cable
ColorMulticolor
Length10 ft.
Connector Detail1 x N-Type Male Antenna

Questions about this item

What equipment do I need that has N-female ports to connect this 952310 cable?

You need a Wilson in-building amplifier with N-connectors, a splitter or tap with N-female ports, and an indoor or outdoor antenna that also uses N-female connectors.

Can I run this 10 ft cable alongside older RG-6 coax without degrading the signal?

Yes, the ultra low loss design attenuates less than 1 dB over the 10 ft run, so it adds minimal loss compared to older higher-loss cables in the same path.

How can I verify the 952310 cable is passing signal correctly after installation?

Check the amplifier's signal-strength LEDs or meter; a healthy reading with less than 1 dB drop across the 10 ft link confirms the cable is working as intended.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.