Wadermoon VGA Extension Cables 3x8(6+2Pin) 240mm Gray

Extension Cables with ARGB Sync

The Wadermoon kit provides three 240 mm VGA extensions, each terminating in an 8-pin (6+2) connector for graphics-card power. Addressable RGB lighting runs along the cables and synchronises with motherboard software from major vendors. The 18 AWG conductors are wrapped in a three-layer construction that omits traditional heat-shrink tubing. This set suits builders who want illuminated cable runs without a separate controller.

18 AWG Conductors and 240 mm Reach

Each extension uses 18 AWG wire for the power path, giving sufficient cross-section for typical GPU loads. The 24 cm length adds routing flexibility inside mid-tower chassis while keeping voltage drop low. The heat-shrink-less design relies on an insulated middle layer and a soft nylon outer braid for protection. Builders running multiple high-wattage cards or needing longer runs to rear-mounted PSUs will find the fixed length limiting.

Sleeved Kit for Clean Routing

The ultra-soft sleeving and included combs allow tight bends and parallel alignment for tidy back-routing. An independent lighting circuit separates the RGB guide layer from the power conductors, preventing signal interference. Compatibility spans standard ATX power supplies, so no proprietary connectors are required. Systems without a 5 V ARGB header or with tightly spaced PCIe slots cannot use the lighting or may need alternative cable routing.