We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Short Y-splitter cable with one blue VGA male plug and two blue VGA female sockets

Vszerda

Vszerda VGA Y-splitter cable 1 male to 2 female 1 foot

SKU CH-SEWD-11FJY

Duplicates one VGA source to two monitors with 15-pin male and dual female connectors, supporting 1080p and lower resolutions

  • Duplicate one VGA source to two monitors with a single 15-pin male plug and two female ports
  • Supports 480p, 720p, 1080i and 1080p resolutions for clear mirrored display
  • Double magnetic-ring shielding and woven net core reduce interference for stable signal transmission
  • Plug-and-play passive adapter needs no driver, external power or software setup
  • Compatible with 800x600 SVGA, 1024x768 XGA and 1600x1200 UXGA monitor modes

VGA Y-splitter for screen duplication

This passive adapter splits a single VGA source into two mirrored displays, ideal for presentations, security monitoring or multi-room setups. It requires no drivers or external power, so you simply connect the male end to the computer and attach two VGA cables to the female ports. The one-foot length keeps the connection tidy at the source.

Passive design with double magnetic rings

The cable draws no power and adds no active electronics, so it runs silently and produces no heat. Double magnetic rings and multi-layer shielding protect the analog signal from interference, helping maintain a stable picture at supported resolutions. Because it is passive, signal quality depends on the length and quality of the attached VGA cables.

Fits any 15-pin VGA port, cables sold separately

The 15-pin male connector plugs directly into laptops, desktops, projectors or TVs with a VGA output, while the two female ports accept standard VGA cables for the displays. This splitter only duplicates the screen; it cannot extend the desktop across monitors. Audio must be routed separately, and very long display cables may reduce image clarity.

Highlights

  • Duplicate one VGA source to two monitors with a single 15-pin male plug and two female ports
  • Supports 480p, 720p, 1080i and 1080p resolutions for clear mirrored display
  • Double magnetic-ring shielding and woven net core reduce interference for stable signal transmission
  • Plug-and-play passive adapter needs no driver, external power or software setup
  • Compatible with 800x600 SVGA, 1024x768 XGA and 1600x1200 UXGA monitor modes

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the Vszerda VGA Y-splitter cable and what step is often missed?

Plug the 15-pin VGA male end into the computer, then attach two separate VGA cables (sold separately) from the 15-pin female ends to each monitor; the step often missed is forgetting that VGA cables for the displays are not included.

What maintenance or replacement will this splitter need later?

As a passive adapter with no moving parts or power supply, it requires no scheduled maintenance; only replace it if the connectors become loose or the cable jacket is damaged.

What is the first limit I will hit under sustained use?

The passive design only mirrors the same signal to both screens at up to 1080p or 1600x1200 resolution; it cannot extend the desktop, carry audio, or drive cables long enough to cause signal degradation.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.