Vszerda
Vszerda RP-SMA Coaxial Extension Cable 10ft 2-Pack
Two 10 ft RP-SMA male-to-female coaxial cables extend Wi-Fi antennas for optimal 2.4 GHz placement with 50 ohm low-loss wire
- ColorBlack
- Low-loss RG174 cable preserves signal strength over distance
- 10 ft length lets you position antennas for best coverage
- RP-SMA male-to-female connectors fit Wi-Fi routers and bridges
- 50 ohm impedance matches wireless LAN and cellular gear
- Two-cable pack equips dual-antenna or multi-point setups
10 ft RP-SMA extension cable two-pack
Two RP-SMA male-to-female coaxial cables extend antenna placement by three metres each. The 50 ohm RG174-type wire is built for wireless LAN, cellular and similar RF gear rather than broadcast TV. Each cable uses pure copper connectors with oxidised finish for reliable contact. The pair suits routers, bridges, desktop antennas and network adaptors needing remote antenna positioning.
Low-loss behaviour over the full length
The dedicated 50 ohm engineering wire keeps attenuation minimal across the entire ten-foot run. Signal integrity remains consistent whether the link operates in the 2.4 GHz band or other supported wireless LAN frequencies. Connectors are rated for repeated mating cycles without measurable degradation. The construction avoids the high loss typical of generic thin coax when run at full extension.
IEEE 802.11 a/b/g/n compatibility ceiling
The cables are specified for IEEE 802.11a, b, g and n wireless LAN standards and 24 dBi antenna configurations. They do not support television or broadcast antenna interfaces. Maximum usable frequency is defined by the listed wireless LAN standards rather than broader microwave ranges. Users requiring connections beyond these protocols or for TV distribution should select a different cable type.
Highlights
- Low-loss RG174 cable preserves signal strength over distance
- 10 ft length lets you position antennas for best coverage
- RP-SMA male-to-female connectors fit Wi-Fi routers and bridges
- 50 ohm impedance matches wireless LAN and cellular gear
- Two-cable pack equips dual-antenna or multi-point setups
Specifications
| Brand | CORONIR |
|---|---|
| Model | RG1745012 |
| Part Number | RG1745012 |
| Color | Black |
Questions about this item
Does the 10ft cable add noticeable signal loss when running all day?
The RG174 50 ohm wire is built for low loss on wireless LAN links, so a 10ft run keeps attenuation minimal during continuous use.
What must I already have for these RP-SMA male-to-female cables to connect?
You need a device or antenna with an RP-SMA female port and a matching RP-SMA male antenna or pigtail to complete the link.
Will the 2.4 GHz 24 dBi antenna I already own work with this extension?
Yes, the cable is compliant with IEEE 802.11b/g/n networks and matches the 50 ohm impedance used by typical 2.4 GHz high-gain antennas.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
