We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black RJ45 male to 8-pin female screw terminal adapters, 5.4cm x 3.7cm

Vszerda

Vszerda RJ45 8P8C male to 8-pin female screw terminal adapter 2-pack black 5.4cm x 3.7cm

SKU CH-5WCN-SB45J

Two-pack RJ45 male to 8-pin screw terminal adapters accept AWG 28-16 wire for Cat5 to Cat7 UTP cable without soldering

  • Wired to EIA/TIA 568B standard for structured cabling
  • Tool-free termination with only a screwdriver and wire stripper
  • Two adapters included for multiple connection points
  • Compatible with UTP Cat5, Cat6 and Cat7 cables
  • Shielded metal housing protects signal integrity

Two-pack RJ45 screw-terminal adapter

This two-pack supplies male RJ45 8P8C plugs that convert to eight female screw terminals. Each unit measures 5.4 cm by 3.7 cm and is finished in black. The adapters accept solid or stranded conductors from AWG 28 to 16 and require only a screwdriver and wire stripper for termination. Installers can terminate UTP cables without soldering, saving time on site.

Behaviour under sustained use

The terminals are wired to the EIA/TIA 568B standard for structured cabling. The supplier states the adapters are not recommended for actual Ethernet traffic, so sustained network loads are not a supported use case. They are intended for basic power or data distribution and for splitting pairs on Cat5, Cat6 or Cat7 cables. Continuous duty should be limited to low-voltage signalling or control circuits.

568B wiring decides suitability

The single specification that determines fit is the fixed 568B pin-out on the RJ45 male connector. If the connected equipment expects a different wiring scheme, the adapter will not function correctly. Buyers who need a different pin assignment or who require certified Ethernet performance should select an alternative product.

Highlights

  • Wired to EIA/TIA 568B standard for structured cabling
  • Tool-free termination with only a screwdriver and wire stripper
  • Two adapters included for multiple connection points
  • Compatible with UTP Cat5, Cat6 and Cat7 cables
  • Shielded metal housing protects signal integrity

Specifications

No published specifications for this item yet.

Questions about this item

Does the 8-pin screw terminal block generate any heat or electrical noise when left connected to a powered circuit all day?

The adapter is a passive wiring block with no active electronics, so it produces no heat or electrical noise of its own; any warmth would come only from the current flowing through the connected wires.

What tools do I need to terminate wires into the female screw terminals on this adapter?

Only a small screwdriver and a wire stripper are required; the bolt screw shield terminals accept AWG 28-16 solid or stranded wire and need no soldering.

Will the male RJ45 plug on this adapter mate reliably with the RJ45 ports on my older Cat5 patch panel and CCTV baluns?

Yes — the plug follows the EIA/TIA 568B pinout and fits standard RJ45 jacks on Cat5, Cat6 or Cat7 equipment, making it compatible with legacy patch panels and video baluns.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.