We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Three black braided PWM fan splitter cables, ten inches long, each with one four-pin and two three-pin connectors

Vszerda

Vszerda PWM Fan Splitter Cable 10 inches 3 Pack Black 3 Way 4 Pin

SKU CH-XQCZ-4TFKP

Three-way 4-pin PWM splitter cables connect three fans to one motherboard header for synchronised speed control

  • Connect three fans from one header for increased case airflow
  • PWM speed control synchronises all connected fans automatically
  • Braided nylon sleeve with 24AWG wire ensures flexible, durable routing
  • Ten‑inch length fits standard ATX builds without excess slack
  • Three cables per pack supply multiple headers or spare units

Three-way PWM fan splitter for multi-fan setups

This Vszerda splitter cable lets a single motherboard 4-pin header drive three cooling fans at once. One branch carries a 4-pin connector while the other two use 3-pin plugs, so PWM speed control reaches every attached fan. The pack contains three identical cables, ready for builds that need more airflow than a single header can support.

Braided 24 AWG wires with 10-inch reach

Each cable uses 24 AWG conductors wrapped in a black nylon braid that resists kinking and abrasion during routing. The 10-inch length gives enough slack to reach fans across a typical ATX chassis without leaving excess loops. Dense sleeving keeps the bundle tidy behind the motherboard tray and protects the wires from sharp case edges.

Replaces single-fan headers when case airflow

Builders who have exhausted motherboard fan headers can use these splitters to add two extra fans per header without a powered hub. The upgrade makes sense when the board lacks enough PWM headers for front, top and rear intake or exhaust layouts. It does not suit systems that need independent speed curves per fan, because all three fans follow the same PWM signal.

Highlights

  • Connect three fans from one header for increased case airflow
  • PWM speed control synchronises all connected fans automatically
  • Braided nylon sleeve with 24AWG wire ensures flexible, durable routing
  • Ten‑inch length fits standard ATX builds without excess slack
  • Three cables per pack supply multiple headers or spare units

Specifications

No published specifications for this item yet.

Questions about this item

What does a 4-pin PWM fan header split into with this cable?

One 4-pin motherboard header splits into three fan connectors: one 4-pin and two 3-pin, letting all three fans run at the same PWM-controlled speed.

How much clearance does the 10 inch length and 24AWG braided sleeving need inside a case?

Each splitter is 10 inches long with flexible black nylon braid over 24AWG wire, so it routes easily behind motherboard trays and through standard grommets without kinking.

Which fan connector should I plug in first to get correct speed reporting?

Attach the single 4-pin fan lead to the splitter’s 4-pin branch; the motherboard reads its tach signal and drives all three fans at identical PWM duty cycles.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.