We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black braided PWM fan splitter cables, each 11.8 inches, one 4-pin female to three male connectors

Vszerda

Vszerda PWM Fan Splitter Cable 1 to 3 11.8in 2 Pack internal power cable

SKU CH-SEN6-Y18CF

Splits one PWM header into three fan connections with 11.8in braided cables, sold as a two-pack

  • Connect three fans from one header with PWM speed control
  • Extend reach by 11.8 inches for flexible routing in large cases
  • Black braided sleeving protects wires from dust and snagging
  • Daisy-chain multiple cables to scale fan count as needed
  • Works with both 4-pin and 3-pin fans for broad compatibility

PWM fan splitter for three fans

This cable splits a single 4-pin PWM header into three fan connections, letting one motherboard port control three case fans with speed regulation. One output keeps the full 4-pin PWM signal while the other two provide 3-pin voltage control. It is aimed at builders who need extra fan headers without adding a controller hub.

Braided 11.8 inch cable installs in seconds

Each splitter measures 11.8 inches (30 cm) and is wrapped in black braided sleeving that resists dust and wire fatigue. The 4-pin female end plugs into the motherboard and the three male ends attach to 4-pin or 3-pin fans. Daisy-chaining multiple splitters is possible, but total current must stay within the single header rating.

Handles three fans on one header

The splitter comfortably powers three typical case fans from one PWM header while preserving speed control on the 4-pin branch. It runs out of headroom when combined fan draw exceeds the motherboard header limit, so high-current or server-grade fans should use a powered hub instead. Buyers needing more than three fans per header or independent speed curves for each fan will need a different solution.

Highlights

  • Connect three fans from one header with PWM speed control
  • Extend reach by 11.8 inches for flexible routing in large cases
  • Black braided sleeving protects wires from dust and snagging
  • Daisy-chain multiple cables to scale fan count as needed
  • Works with both 4-pin and 3-pin fans for broad compatibility

Specifications

No published specifications for this item yet.

Questions about this item

How can I confirm the PWM splitter is regulating all three fans correctly after I plug it in?

Connect the 4-pin female end to a motherboard PWM header, attach up to three fans to the male connectors, then watch the RPM readings in BIOS or fan-control software — all fans should spin and report speeds that change together when the header duty cycle changes.

What connectors and cables are included in the two-pack, and is anything else required to use them?

Each pack contains two braided splitter cables, each 30 cm long with one 4-pin female connector splitting to one 4-pin male and two 3-pin male connectors; no extra parts are needed if your motherboard has a standard 4-pin fan header.

Should I choose the 11.8-inch version or a different length for a full-tower build?

The only length offered is 11.8 inches (30 cm); if you need more reach you can daisy-chain multiple splitters together.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.