We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat beige ribbon cable with dual right-angle PCIe x1 connectors, 14 cm overall length

Vszerda

Vszerda PCIe x1 extension cable dual 90 degree 14cm

SKU CH-ZJQ8-6TET0

A 14 cm PCIe x1 riser with dual 90 degree connectors fits tight 1U or 2U chassis and supports cards up to x16 size at x1 speed

  • Extends PCIe x1 slots with dual 90-degree connectors for tight chassis
  • 14 cm total length with 10 cm flexible ribbon fits 1U and 2U cases
  • Supports x1, x4, x8 and x16 cards operating at x1 speed
  • Gold-finger cover and dust-proof design protect contacts during installation
  • Bolted PCB reinforcement prevents solder-point stress and short circuits

PCIe x1 riser with dual 90° connectors

This Vszerda extension cable adds a 14 cm flexible link between a motherboard PCIe x1 slot and an add-in card. The ribbon design fits tight 1U or 2U chassis where a full-height card cannot sit directly on the board. It carries x1 electrical signals while accepting x4, x8 or x16 cards mechanically. No driver installation is required.

Replaces rigid right-angle brackets

A fixed 90° bracket forces the card into one orientation and often blocks adjacent slots. This cable lets the builder route the card sideways or downward, clearing CPU coolers or storage cages. The jump is worth it when the case layout prevents a straight insertion or when multiple risers must share a narrow backplane.

Gold-finger cover and bolted PCB joints

The solder points between ribbon and PCB are swaddled and secured with bolts and nuts to resist vibration in mining rigs. A protective cover shields the gold fingers from dust and oxidation during handling. The axial cable is rated for stable PCIe Gen3 8 Gbps operation under continuous load.

Highlights

  • Extends PCIe x1 slots with dual 90-degree connectors for tight chassis
  • 14 cm total length with 10 cm flexible ribbon fits 1U and 2U cases
  • Supports x1, x4, x8 and x16 cards operating at x1 speed
  • Gold-finger cover and dust-proof design protect contacts during installation
  • Bolted PCB reinforcement prevents solder-point stress and short circuits

Specifications

No published specifications for this item yet.

Questions about this item

How much clearance does the dual 90 degree connector need to fit?

The cable is 10 cm long and 14 cm total, with both ends bent 90 degrees so the card sits parallel to the motherboard slot in a 1U or 2U chassis.

What is the step people miss when installing this riser?

The PCB is bolted to the cable to protect the solder joints, so fasten the riser bracket before plugging the card in to avoid stress on the golden fingers.

What part of this extender wears out first in a mining rig?

The flexible ribbon and gold-finger contacts are rated for PCIe Gen3 8 Gbps; repeated re-seating or vibration can degrade the contact pads over time.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.