We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat black PCIe 4.0 x16 riser cable, right-angle connector, 30 cm length

Vszerda

Vszerda PCIe Gen 4.0 x16 Riser Cable Right Angle 30cm

SKU CH-W3WG-HJ9VP

Right-angle PCIe 4.0 x16 riser cable extends a graphics card 30 cm with an ultra-flexible flat design for clean routing

  • Full PCIe Gen 4.0 x16 bandwidth for maximum GPU throughput
  • Right-angle connector prevents cable strain and eases installation
  • Ultra-soft flat cable folds to 200 mm for tidy routing
  • Shielded design minimises signal delay and electromagnetic interference
  • Backward compatible with PCIe 3.0, 2.0 and 1.0 motherboards

PCIe Gen 4.0 x16 Riser Cable

The Vszerda riser cable extends a graphics card from the motherboard slot using a right-angle connector that reduces strain on the PCB. It delivers full Gen 4.0 x16 bandwidth and remains backward-compatible with Gen 3.0, 2.0 and 1.0 systems. Builders who need to position a GPU vertically or in a tight chassis will find the 30 cm length practical. This cable does not suit builds that require a longer run or a straight connector.

Thermals and Signal Integrity

The flat, ultra-soft ribbon measures 200 mm in its flexible section and folds cleanly without kinking, so airflow around the GPU and motherboard is not blocked. Shielded conductors keep electromagnetic interference low and minimise signal delay across the link. No active cooling or extra power is needed because the cable carries only the PCIe bus signals.

Build Integration

The right-angle plug inserts parallel to the board, freeing vertical clearance above the slot for large coolers or case panels. Compatibility covers current AMD and NVIDIA GPUs including the 3060, 3070, 3080, 3090, 6600, 6700, 6800 and 6900 series alongside X570, B550, Z690 and B660 chipsets. Installers should verify their case has room for the 11.8 in overall length before ordering.

Highlights

  • Full PCIe Gen 4.0 x16 bandwidth for maximum GPU throughput
  • Right-angle connector prevents cable strain and eases installation
  • Ultra-soft flat cable folds to 200 mm for tidy routing
  • Shielded design minimises signal delay and electromagnetic interference
  • Backward compatible with PCIe 3.0, 2.0 and 1.0 motherboards

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the Vszerda PCIe Gen 4.0 x16 riser cable and what step do people get wrong?

Plug the right-angle connector into the motherboard slot first, route the flat 200 mm flexible section, then seat the GPU into the other end; the common mistake is bending the cable tighter than its natural fold radius before both ends are locked.

What maintenance or replacement will the Vszerda PCIe Gen 4.0 x16 riser cable need later?

No scheduled maintenance is required; inspect the connector contacts for dust whenever the GPU is removed and replace the cable only if the right-angle latch or the flat ribbon shows physical damage.

What limit shows up first on the Vszerda PCIe Gen 4.0 x16 riser cable under sustained use?

The 30 cm length and flat ribbon construction keep signal delay minimal, so the first limit under sustained load is the motherboard slot and GPU power delivery, not the cable itself.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.