Vszerda
Vszerda PCIe 6-pin to 2×8-pin (6+2) power splitter cable 20 cm 18AWG
Splits one PCIe 6-pin PSU connector into two 8-pin (6+2) GPU plugs using 18AWG copper over 20 cm
- Powers two graphics cards from one PSU connector
- 18AWG copper conductors deliver stable current
- 20 cm length fits compact mining rigs
- Each output supports 6-pin or 8-pin GPUs
- PCI Express 2.0 compatible connectors
20 cm PCIe 6-pin to dual 8-pin splitter
This Vszerda cable splits a single PSU 6-pin PCIe connector into two 8-pin (6+2) female plugs. It is built for miners or builders who need to power two graphics cards from one 6-pin rail. The 18AWG copper conductors handle the current required by typical mid-range GPUs.
18AWG copper conductor rating
The 18AWG wire gauge is the critical spec that determines safe current delivery. Thinner wire would overheat under dual-GPU load, while thicker wire is unnecessary bulk. This gauge matches the 6-pin source rating so the splitter does not become the bottleneck.
Simple plug-in, watch total draw
Installation is a direct male-to-female connection with no tools required. The 20 cm length keeps routing tidy inside mining frames or compact cases. The common mistake is exceeding the 6-pin source limit; the splitter only divides power, it does not create extra wattage.
Highlights
- Powers two graphics cards from one PSU connector
- 18AWG copper conductors deliver stable current
- 20 cm length fits compact mining rigs
- Each output supports 6-pin or 8-pin GPUs
- PCI Express 2.0 compatible connectors
Specifications
No published specifications for this item yet.
Questions about this item
How does the 2.0 designation affect what this splitter can deliver to a graphics card?
The 2.0 label refers to the PCI Express connector generation; the splitter simply routes the existing 6-pin supply through to two 6+2 outputs without changing voltage or signalling.
Will a single PSU 6-pin connector safely feed two 8-pin (6+2) GPU inputs through this adapter?
The cable uses 18 AWG copper conductors to carry the supply from one 6-pin to two 6+2 connectors; total draw must stay within what the PSU 6-pin rail is rated for.
What clearance is needed to route the 20 cm ribbon between the PSU and a dual-8-pin graphics card?
The flat ribbon measures 20 cm end-to-end with a 6-pin male at one end and two 6+2 females at the other, so allow that length plus connector depth inside the case.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.00114708BTC
In stock
