We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat black ribbon cable with 90 degree PCIe x16 connectors, 20 cm length

Vszerda

Vszerda PCI Express x16 90° Riser Cable 20 cm

SKU CH-CEGN-5G2QX

A 90-degree PCIe 3.0 x16 riser cable extends a graphics card 20 cm with gold-plated contacts and foil shielding for signal integrity

  • Vertical 90° connector lets you route graphics cards in tight cases
  • 20 cm ribbon cable keeps signal paths short for PCIe 3.0 speeds
  • Gold-plated contacts resist oxidation for reliable long-term connectivity
  • Foiled construction shields high-frequency signals from electromagnetic interference
  • Male-to-female x16 design fits most motherboards and graphics cards

Vertical 90-degree PCIe x16 riser

This Vszerda cable routes a graphics card at a right angle using a PCI Express x16 male-to-female ribbon. The 20 cm flexible extension suits small-form-factor builds, mining frames or any layout where the card must sit parallel to the motherboard. Gold-plated contacts and a foiled ribbon preserve signal quality across the link.

PCIe 3.0 signal integrity

The cable is rated for PCIe 3.0 speeds and uses shielded conductors to limit high-frequency impedance and EMI. A 24 cm total length keeps trace delay low while the vertical 90-degree connector reduces strain on the slot. No active components draw extra power or add noise.

Sustained mining and compute loads

Continuous data transfer across the x16 link remains stable because the solder points and gold terminals resist oxidation over long runs. The foil shielding maintains consistent impedance when the card operates at full bandwidth for extended periods. Builders needing longer reach or multiple risers should plan a different cable length.

Highlights

  • Vertical 90° connector lets you route graphics cards in tight cases
  • 20 cm ribbon cable keeps signal paths short for PCIe 3.0 speeds
  • Gold-plated contacts resist oxidation for reliable long-term connectivity
  • Foiled construction shields high-frequency signals from electromagnetic interference
  • Male-to-female x16 design fits most motherboards and graphics cards

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the 90° PCIe x16 riser without stressing the 20 cm ribbon?

Route the ribbon so the 90° connector sits flat against the graphics-card bracket, then secure the card before tightening the motherboard-end latch; bending the 20 cm section sharply at the solder points is the step most builders get wrong.

What maintenance or replacement will the gold-plated contacts need later?

The gold-plated contacts are rated for long life and only need occasional dust removal with compressed air; no scheduled replacement is required unless physical damage occurs.

What limit appears first when the 3.0 x16 link runs sustained mining loads?

The 20 cm foil-shielded ribbon handles PCIe 3.0 x16 signalling continuously; the first practical limit is thermal throttling on the graphics card itself, not the cable.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.