Vszerda OCuLink SFF-8611 4i to 4 SATA 7P Left Angle Cable 50CM

Vszerda OCuLink SFF-8611 4i to 4 SATA Cable

This 50 cm cable connects an OCuLink SFF-8611 4i host port to four SATA drives using left-angle 7-pin connectors. It suits builders adding multiple hard drives or SSDs to a server or workstation backplane where a straight connector would foul adjacent components. The SAS-type cable carries high-speed data between the host controller and each SATA device. Buyers needing right-angle or straight SATA plugs should choose a different cable.

Left-angle SATA connectors ease tight-space routing

The four left-angle 7-pin plugs let cables run parallel to the drive PCB, reducing bend radius in crowded drive cages or 2.5-inch bays. Installation is straightforward: seat the SFF-8611 4i end into the host receptacle and press each SATA connector until it clicks. A common issue is confusing left-angle with right-angle orientation; verify the drive bay layout before ordering to avoid blocked ports or strained wires.

Sustained throughput matches host and drive limits

Under continuous read or write loads the cable passes data at the rate permitted by the attached SATA devices and the host controller without adding measurable latency. The 50 cm length keeps signal loss low for typical chassis depths. Performance will plateau at the slowest link in the chain, so it does not overcome a drive’s own sustained-speed ceiling.