We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Five short black cables with white Molex plugs and black SATA connectors

Vszerda

Vszerda Molex to SATA 4-Pin to 15-Pin 5-Pack 0.1m

SKU CH-NYFV-4RWK7

Five 0.1 m cables convert Molex 4-pin power to SATA 15-pin for legacy PSUs

  • Connect legacy Molex PSUs to modern SATA drives with straight 4-pin to 15-pin connectors
  • Five adapters per pack simplify wiring multiple hard drives or optical drives
  • Short 0.1 metre length keeps internal cable routing tidy and airflow clear
  • Male Molex to female SATA orientation matches standard power-supply and drive ports
  • New condition ensures reliable contacts for every installation

Molex-to-SATA power adapter 5-pack

This five-pack of adapters connects SATA hard drives or optical drives to a power supply that only provides legacy Molex LP4 connectors. Each cable carries a male 4-pin Molex plug on one end and a female 15-pin SATA power connector on the other. The short 0.1 metre length keeps internal cable routing tidy in compact builds.

Thermals noise and power draw

The adapter is a passive cable assembly with no active electronics, so it adds no audible noise and generates no measurable heat of its own. Power draw is limited to whatever the attached SATA device requires, with no additional overhead from the adapter itself.

Behaviour under sustained load

Because the cables contain only copper conductors and moulded connectors, their electrical characteristics remain stable during continuous operation. There are no semiconductors or voltage-regulation components that could throttle or degrade during prolonged heavy use by the connected drives.

Highlights

  • Connect legacy Molex PSUs to modern SATA drives with straight 4-pin to 15-pin connectors
  • Five adapters per pack simplify wiring multiple hard drives or optical drives
  • Short 0.1 metre length keeps internal cable routing tidy and airflow clear
  • Male Molex to female SATA orientation matches standard power-supply and drive ports
  • New condition ensures reliable contacts for every installation

Specifications

No published specifications for this item yet.

Questions about this item

How do I connect the 4-pin Molex plug to my power supply and the 15-pin SATA plug to my drive?

Plug the male Molex connector directly into a free LP4 port on the power supply, then attach the male 15-pin SATA connector to the drive's power socket; the 0.1 m length leaves no slack, so route it before seating both ends.

Will the SATA power connectors or Molex pins degrade and need replacement over time?

The connectors are rated for standard mating cycles; under normal internal use they do not require scheduled replacement, but inspect for bent pins or cracked housings if you frequently disconnect drives.

What is the practical power limit before voltage drop becomes an issue on these 0.1 m cables?

At 0.1 m the resistive loss is minimal, so the limiting factor is the Molex source and the drive's own draw rather than the adapter itself.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.