We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black sleeved Molex to three 3/4-pin fan splitter cable, 10 inch

Vszerda

Vszerda Molex to 3× 3/4-pin fan power splitter cable 10 inch black sleeved 12V only

SKU CH-15QZ-B3QMP

Connects three 3-pin or 4-pin fans to one Molex power connector, 12 V only, 10 inch black-sleeved cable

  • Powers three fans from one Molex connector
  • 12 V output only — no speed control or RPM feedback
  • 10 inch length fits compact builds cleanly
  • Black sleeved jacket protects wires and aids routing
  • Simple 2-wire design keeps installation quick and reliable

Single-rail 12 V splitter

The Vszerda Molex-to-3×3/4-pin cable connects three case fans or a CPU cooler to one four-pin Molex connector from the power supply. It carries only the 12 V and ground lines, so every attached fan runs at full speed without PWM or RPM feedback. Builders who want a simple, sleeved power distribution cable for constant-speed cooling will find it fits the role.

Three fans from one Molex

The 10-inch sleeved harness splits a single Molex 423/425-style plug into three combined 3-pin/4-pin headers, each receiving 12 V DC only. Because the two-wire design omits the tachometer and PWM pins, fan curves and speed reporting are unavailable; the practical limit is three fans drawing within the Molex connector’s current rating. Systems that rely on motherboard fan headers for speed control cannot use this adapter for that purpose.

No PWM control included

The bundle is the cable itself; there is no controller, software or additional wiring to enable speed regulation. Users who need variable fan speeds must connect fans directly to motherboard headers or add a separate PWM hub. The black sleeving adds abrasion resistance and a cleaner look inside the case, but it does not change the electrical limitation to fixed 12 V operation.

Highlights

  • Powers three fans from one Molex connector
  • 12 V output only — no speed control or RPM feedback
  • 10 inch length fits compact builds cleanly
  • Black sleeved jacket protects wires and aids routing
  • Simple 2-wire design keeps installation quick and reliable

Specifications

No published specifications for this item yet.

Questions about this item

Will the single Molex connector on this Vszerda splitter power three fans from an older PSU that only has Molex leads?

Yes, the cable takes one 4-pin Molex from the PSU and branches to three 3-pin or 4-pin fan headers, delivering 12 V DC to each fan.

How can I confirm the fans are receiving power once I connect the 10-inch sleeved cable?

The fans will spin at full 12 V speed immediately; since the adapter carries only power wires, there is no RPM signal or PWM control to check.

What connectors are included on the Vszerda Molex-to-triple-fan cable and is anything else needed?

The cable has one 4-pin Molex male plug and three combined 3-pin/4-pin fan sockets; no extra cables or adapters are required.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.