We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Vszerda KZ4476 4-pin Molex to 5 SATA power cable 18AWG 40cm

Vszerda

Vszerda KZ4476 4-pin Molex to 5 SATA power cable 18AWG 40cm

SKU CH-9MTE-TQSKK

Adapts one 4-pin Molex connector to five 15-pin SATA power ports using 18AWG wire over a 40cm length

  • Converts one Molex connector into five SATA power ports
  • 18 AWG wire handles high-current loads for multiple drives
  • 40 cm length reaches drives across standard chassis layouts
  • Supports HDD and SSD power connections in mining rigs
  • Model KZ4476 identifies this specific adapter configuration

Molex to 5 SATA power adapter

The Vszerda KZ4476 cable converts a single 4-pin Molex connector into five 15-pin SATA power ports. It uses 18AWG wire and spans about 40cm, making it suitable for powering multiple hard drives or SSDs from one rail. Miners and builders expanding drive counts will find it a compact solution.

Check your power supply connectors

Ensure the PSU has an available 4-pin Molex output before ordering. Verify that each target drive accepts a standard 15-pin SATA power plug. The 18AWG conductors are rated for typical drive currents, but total draw across all five ports must stay within the Molex rail limit.

Fits tight drive cages and mining frames

At roughly 40cm the lead reaches drives in stacked bays without excess slack. Five SATA heads let one cable serve a small array, freeing other Molex lines for fans or lighting. The straight connectors keep the loom narrow for clean routing behind motherboard trays.

Highlights

  • Converts one Molex connector into five SATA power ports
  • 18 AWG wire handles high-current loads for multiple drives
  • 40 cm length reaches drives across standard chassis layouts
  • Supports HDD and SSD power connections in mining rigs
  • Model KZ4476 identifies this specific adapter configuration

Specifications

No published specifications for this item yet.

Questions about this item

What connectors come on the cable and do I need any extra parts?

The cable has one 4-pin Molex plug and five 15-pin SATA power connectors. No additional adapters are required to run five SATA drives from a single Molex outlet.

Which wire gauge should I choose for my build?

This model uses 18AWG wire, which is the only gauge offered for the KZ4476. It is rated for standard SATA power loads in desktop PCs and mining rigs.

Will the 40 cm length reach drives in a full-tower case?

The bus length is about 40 cm from the Molex plug to the last SATA connector, so it suits typical mid-tower layouts; measure your drive bay spacing to confirm.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.