We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black right-angle IEC C14 male to C13 female power adapter, moulded PVC body

Vszerda

Vszerda IEC 320 C14 to C13 90-degree power adapter

SKU CH-5QJE-BF96R

Left-angle IEC 320 C14 male to C13 female adapter rated 10 A 250 V for tight spaces behind wall-mounted displays

  • Right-angle IEC C14 to C13 fits tight wall-mount spaces
  • Rated 10 A 250 V handles standard PSU and UPS loads
  • Fully moulded PVC construction resists wear and strain
  • Converts C14 male to C13 female without voltage change
  • Compact 90-degree adapter eases cable routing behind equipment

90-degree C14-to-C13 adapter for tight spaces

The Vszerda IEC 320 C14 male to C13 female adapter provides a 90-degree angle connection rated for 10A at 250V. It is built with fully moulded PVC construction and carries a CE test certificate. This adapter suits installers routing power behind wall-mounted displays or inside crowded racks where straight plugs cannot fit.

Replaces straight IEC cords that bend sharply

A straight C13 plug often forces the cable to bend at a sharp radius against a wall or chassis, stressing the connector and the equipment inlet. The right-angle design eliminates that bend, reducing mechanical strain and improving airflow in dense cabinets. The improvement is worthwhile whenever the equipment inlet faces a flat surface with less clearance than a straight plug requires.

Fits standard IEC 320 inlets and outlets

Connect the C14 male end to any IEC 320 C13 outlet on a PDU, UPS or PSU, then attach the C13 female end to the device inlet. The adapter only changes the plug orientation; it does not transform voltage, so the connected equipment must already match the supply voltage. Its compact moulded body adds minimal length, leaving more room for cable management behind the mounted device.

Highlights

  • Right-angle IEC C14 to C13 fits tight wall-mount spaces
  • Rated 10 A 250 V handles standard PSU and UPS loads
  • Fully moulded PVC construction resists wear and strain
  • Converts C14 male to C13 female without voltage change
  • Compact 90-degree adapter eases cable routing behind equipment

Specifications

No published specifications for this item yet.

Questions about this item

How much clearance behind the device does the 90-degree C14 plug need to fit?

The right-angle C14 male connector projects sideways from the C13 female socket, letting the cable run parallel to the wall so a flush-mounted TV or PDU only needs the adapter's own depth.

Which way round do I connect the C14 male and C13 female ends when installing it?

Plug the C14 male pins into the PDU, UPS or wall outlet first, then attach the equipment's C13 power cord into the C13 female receptacle.

When should I replace this adapter if it stays plugged in continuously?

Replace it if the molded PVC body shows cracking, the pins become loose or discoloured, or the 10 A 250 V rating is exceeded by the connected load.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.