We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black flat ribbon cable with one large four-pin IDE plug and six fifteen-pin SATA power connectors

Vszerda

Vszerda IDE to SATA Power Cable 4 Pin 1 to 6×15 Pin Splitter 18CM+8CM 18AWG

SKU CH-6599-EN9RY

Splits one 4-pin IDE power connector into six 15-pin SATA plugs using 18AWG tinned copper wire in a flat parallel layout

  • Powers six SATA drives from one 4-pin IDE connector
  • 18 AWG tinned copper wire for reliable power delivery
  • Parallel flat design keeps cables neat and eases routing
  • 15-pin SATA receptacles plus 15-pin male plug for secure connections
  • Plug-and-play adapter adds drives without extra power-supply cables

Versatile IDE-to-SATA Power Splitter

This adapter converts a single large 4-pin IDE connector into six 15-pin SATA power sockets. It is intended for builders who need to supply multiple hard drives, solid-state drives, optical drives or PCIe cards from one power-supply lead. The cable measures 18 cm from the IDE plug to the first SATA socket, then 8 cm between each subsequent socket. All conductors are 18 AWG tinned copper for reliable current delivery.

Low-Profile Parallel Cable Design

The flat, parallel wire layout keeps the loom tidy inside a chassis and simplifies routing through tight cut-outs. No sleeving or extra bundling is required, so airflow is not impeded by bulky cable clusters. Each SATA receptacle and the single SATA pass-through plug follow the standard pinout, ensuring plug-and-play compatibility with any compliant drive or device.

Steady Supply for Up to Six Drives

Under sustained operation the 18 AWG conductors maintain consistent voltage across all six outputs without the voltage sag seen in thinner splitter cables. The rigid yet flexible parallel construction resists fatigue from repeated drive swaps or case maintenance. Builders who need more than six SATA power connections or who lack an available 4-pin IDE header will require a different power-distribution solution.

Highlights

  • Powers six SATA drives from one 4-pin IDE connector
  • 18 AWG tinned copper wire for reliable power delivery
  • Parallel flat design keeps cables neat and eases routing
  • 15-pin SATA receptacles plus 15-pin male plug for secure connections
  • Plug-and-play adapter adds drives without extra power-supply cables

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the Vszerda IDE to SATA power splitter cable?

Connect the single large 4-pin LP4 plug to your power supply, then attach up to six SATA device power connectors along the flat parallel cable.

What maintenance or replacement will the Vszerda splitter need over time?

Inspect the 18AWG tinned copper wires and 15-pin SATA connectors periodically for cracked insulation or loose pins; replace the cable if any conductor is damaged.

What is the first limit reached when powering six drives continuously with this cable?

The 18AWG conductors set the current-carrying capacity, so total draw across all six SATA devices must stay within the gauge rating.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.