We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Green rectangular PCB adapter with E1.S female and M.2 key M male connectors

Vszerda

Vszerda EDSFF E1.S to M.2 NVMe Adapter SF-048

SKU CH-M462-X0VVJ

Converts an EDSFF E1.S SSD to an M.2 NVMe module using a PCIe x4 4.0 interface and 67-pin M-key connector, requiring 4-pin power for servers and data centres

  • Converts EDSFF E1.S drives to M.2 NVMe format
  • PCIe 4.0 x4 interface delivers full NVMe bandwidth
  • 4-pin power connector required for drive operation
  • Supports double-sided M.2 modules up to 1.5 mm height
  • Compact 3.94-inch square PCB fits server and IoT chassis

EDSFF E1.S to M.2 NVMe adapter

The Vszerda SF-048 converts an EDSFF E1.S ruler SSD into a standard M.2 key M form factor. It connects through a PCIe x4 Rev. 4.0 interface and requires a 4-pin power connection to operate. The adapter suits data-centre, server and IoT deployments that need to reuse E1.S drives in M.2 slots.

Who this suits and who it does not

Builders with an available M.2 key M slot running PCIe x4 and a spare 4-pin power header can install E1.S storage directly. It is not for systems lacking an M.2 key M connector or a 4-pin power source. Buyers needing to connect drives with a different physical interface should look elsewhere.

Deciding specification

The PCB is larger than a 2280 module and components reach 1.5 mm in height, so double-sided M.2 SSDs are supported. Verify that your chassis and motherboard clearance accommodate the 3.94-inch square footprint before purchase.

Highlights

  • Converts EDSFF E1.S drives to M.2 NVMe format
  • PCIe 4.0 x4 interface delivers full NVMe bandwidth
  • 4-pin power connector required for drive operation
  • Supports double-sided M.2 modules up to 1.5 mm height
  • Compact 3.94-inch square PCB fits server and IoT chassis

Specifications

No published specifications for this item yet.

Questions about this item

Will the adapter’s 3.94-inch square footprint fit inside my 1U server tray?

The board measures 3.94 by 3.94 by 0.39 inches, so verify your tray’s internal clearance before ordering.

Which power connector must be attached for the adapter to function?

A 4-pin power plug must be connected; the card will not operate without it.

What is the tallest M.2 module this carrier can accept?

Components on the M.2 module must not exceed 1.5 mm in height, allowing double-sided modules within that limit.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.