Vszerda Down Angled DisplayPort Cable 4K 60Hz 90 Degree Silver Sleeve 100cm

Angled DisplayPort cable for tight rear I/O

This 100 cm DisplayPort cable uses a 90 degree down-angled connector to fit behind graphics cards or monitors where straight plugs would hit a case wall or desk edge. It carries 4K 60 Hz video with a rated bandwidth of 32.4 Gbps and is backward compatible with DP 1.3 and 1.2 devices. Gold-plated contacts and a welded strain-relief collar reduce the chance of damage if the cable is tugged. The silver aluminium alloy shell and woven braid sleeve add durability without stiffness.

Sustained 4K 60 Hz signal integrity

At the full 32.4 Gbps rate the copper conductors maintain a stable 4K 60 Hz link without the drop-outs that cheaper cables show after several minutes of gaming or rendering. The gold plating resists oxidation so contact resistance stays low over repeated connect and disconnect cycles. The braided jacket prevents kinking when the cable is routed through tight cable-management channels, keeping impedance consistent along the whole length. Backward compatibility with DP 1.3 and 1.2 means the same cable works when you swap an older monitor into the chain.

Check port orientation and version before ordering

Verify that the DisplayPort socket on your graphics card or monitor faces a direction where a down-angled plug points toward free space rather than into a bracket or another connector. Confirm that your source and display both support at least DP 1.2 so the 4K 60 Hz mode is available; older DP 1.1 ports will fall back to lower resolutions. Measure the straight-line distance between the two ports to ensure the 100 cm length reaches without tension. No adapter or active converter is included in the package.