We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Six black 80 cm PCIe cables with 6-pin to 6+2-pin connectors

Vszerda

Vszerda 6PCS PCIe 6Pin to 6+2 Pin Power Cable 80cm computer power cord

SKU CH-SPXQ-BRXBS

Six 80 cm cables convert a server 6-pin connector to a 6+2-pin PCIe plug using 18 AWG tinned-copper wire

  • Specifications80cm
  • Six cables connect dual-GPU rigs or mining boards from one 6-pin source
  • 18 AWG tinned-copper conductors carry PCIe power with low resistance
  • 6-pin to 6+2-pin ends fit both 6-pin and 8-pin graphics cards
  • 80 cm length reaches across full-tower chassis without strain
  • 1007-spec wire meets standard insulation requirements

Six-cable kit for server GPU power

This set contains six 80 cm cables that convert a server 6-pin output into a 6+2-pin PCIe connector. Each cable uses 18 AWG 1007 wire with tinned-copper conductors. The pack is aimed at builders who power graphics cards or mining modules from server-style 6-pin converter boards.

Replaces makeshift adapters and short leads

When a server power supply only offers 6-pin ports, these cables remove the need for daisy-chained adapters or custom wiring. The 80 cm length gives enough reach for typical chassis routing, and the 6+2-pin end fits both 6-pin and 8-pin graphics-card sockets. The jump is worth it whenever the stock cables are too short or the wrong pin count.

Handles single-GPU or multi-GPU mining loads

Six cables support up to six graphics cards or power modules drawing from 6-pin server headers. The 18 AWG gauge is rated for the current those connectors are designed to deliver. Runs out when a build needs more than six connections, longer runs beyond 100 cm, or a different source connector such as 8-pin or 12VHPWR.

Highlights

  • Six cables connect dual-GPU rigs or mining boards from one 6-pin source
  • 18 AWG tinned-copper conductors carry PCIe power with low resistance
  • 6-pin to 6+2-pin ends fit both 6-pin and 8-pin graphics cards
  • 80 cm length reaches across full-tower chassis without strain
  • 1007-spec wire meets standard insulation requirements

Specifications

BrandVszerda
Specifications80cm

Questions about this item

What clearance does the 80 cm cable need inside a case?

The 80 cm length requires enough slack for routing from a server 6-pin converter board to a graphics card 6+2-pin connector without sharp bends.

How is the 6-pin to 6+2-pin cable connected, and what step is often missed?

Plug the 6-pin male end into the server converter board and the 6+2-pin end into the GPU; the extra 2 pins must be seated fully or the card will not receive the 8-pin power it expects.

When should the 18 AWG tinned-copper cable be replaced?

Replace the cable if the insulation shows cracking, the tinned copper conductors darken or corrode, or the 6-pin or 6+2-pin connectors become loose or melted.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.