We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Five black sleeved 4-pin PWM fan splitter cables 27cm long

Vszerda

Vszerda 5PCS 4Pin PWM Fan Splitter Cable 1 to 3 27cm internal power cable

SKU CH-STV5-EXN1N

Connects three PWM fans to one motherboard header using 27 cm tinned-copper 24 AWG cables

  • Split one PWM header into three fan connections
  • 27 cm length reaches most chassis fan positions
  • Black snakeskin sleeve keeps internal wiring tidy
  • Tinned copper 24 AWG conductors carry power reliably
  • Two ports omit tach wire to prevent signal collision

Five-way PWM fan splitter kit

This pack contains five 27 cm cables that turn one motherboard 4-pin PWM header into three fan connections, using 1007 24 AWG tinned-copper conductors with a black snakeskin sleeve for tidy routing. Each cable weighs about 18 g and follows the standard 11/0.12 mm strand layout. The design lets two or three 4-pin fans share a single header for automatic speed control.

Builders with limited fan headers

The splitter suits anyone who needs to run multiple PWM fans from one motherboard socket, such as dual-fan radiators or triple-fan intake arrays. It will not help users who require independent speed reporting from every fan, because two of the three branches omit the tachometer wire to prevent signal collisions. Systems that rely on per-fan RPM monitoring should look at a powered hub instead.

Steady shared PWM control

Under continuous load the cable simply passes the motherboard PWM signal to all attached fans, so they ramp together without extra electronics. Because the sense line is present on only one branch, the board reads a single RPM value while the other fans follow the same duty cycle. The 24 AWG conductors and tinned copper keep resistance low enough for typical case-fan currents during sustained operation.

Highlights

  • Split one PWM header into three fan connections
  • 27 cm length reaches most chassis fan positions
  • Black snakeskin sleeve keeps internal wiring tidy
  • Tinned copper 24 AWG conductors carry power reliably
  • Two ports omit tach wire to prevent signal collision

Specifications

No published specifications for this item yet.

Questions about this item

Does my motherboard need a 4-pin PWM header for this splitter to work?

Yes, the splitter plugs into one 4-pin PWM header and provides three 4-pin PWM fan connectors.

Can I connect older 3-pin fans to the three outputs?

Each output accepts both 3-pin and 4-pin fans, though only two connectors carry the speed-sense wire.

How do I verify the fans are running under PWM control after installation?

Check the BIOS or fan-control software — all connected fans should report RPM and respond to the same PWM curve.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.