We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black sleeved 10 inch PWM fan splitter cables 1 to 4

Vszerda

Vszerda 4-Pin PWM Fan Splitter Cable 1 to 4 10 inch 2-Pack

SKU CH-QV5R-2YZ6J

A 10-inch PWM splitter connects four fans to one motherboard header with synchronised speed control

  • Connects four PWM fans to one motherboard header
  • 10 inch sleeved cables keep builds tidy
  • Single tachometer wire gives accurate RPM reading
  • All fans follow identical PWM speed curve
  • Works with both 4-pin and 3-pin fan plugs

PWM Fan Splitter Hub

The Vszerda 4-pin PWM splitter cable lets a single motherboard header drive up to four fans at once. Each 10 inch lead is sleeved in black for tidy routing inside the case. The two-pack gives builders enough hubs for multiple chassis zones. It suits anyone expanding case airflow without adding a dedicated controller.

Thermals Noise Power

Only the fan plugged into the full 4-pin connector reports its RPM to the motherboard; the other three connectors omit the tachometer pin to prevent signal conflicts. All four fans receive the identical PWM duty cycle so they spin in unison. The passive cable adds no active electronics and draws negligible power beyond the fans themselves.

Sustained Load Behaviour

Under continuous operation the splitter simply passes the motherboard PWM signal to every attached fan without alteration. Fan speeds therefore track the system curve exactly as configured in software such as AI Suite or similar utilities. No onboard logic or thermal throttling is present so behaviour remains consistent for the duration of the load.

Highlights

  • Connects four PWM fans to one motherboard header
  • 10 inch sleeved cables keep builds tidy
  • Single tachometer wire gives accurate RPM reading
  • All fans follow identical PWM speed curve
  • Works with both 4-pin and 3-pin fan plugs

Specifications

No published specifications for this item yet.

Questions about this item

How do I connect four fans to one motherboard header using this splitter?

Plug the single female end into the motherboard 4-pin header, then attach each fan to the four male connectors; only the full 4-pin connector passes the RPM signal back to the board.

What maintenance will this cable need over time?

No scheduled maintenance is required; inspect the sleeved wiring and connectors periodically for dust build-up or physical damage and reseat if a fan stops reporting speed.

What is the first limitation I will hit when running all four fans continuously?

The motherboard header's current rating limits total fan draw, and only one fan's RPM is monitored while all four follow the same PWM signal.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.