We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small green PCB adapter board with 39 pin IDE connector and SATA ports plus data power cable

Vszerda

Vszerda 39 Pin IDE to SATA Adapter 3.5 inch HDD Converter with Data Power Cable

SKU CH-4ZTT-WJ8YD

Converts 3.5-inch IDE hard drives or optical drives to SATA with a 39-pin adapter, supports up to 1000G capacity, and works plug-and-play on 32-bit and 64-bit Windows systems

  • Connect 3.5-inch IDE drives to SATA motherboard ports
  • Supports parallel ATA drives up to 1000G capacity
  • Plug-and-play operation with no driver installation needed
  • Compatible with Windows XP, 7, 8 on 32-bit and 64-bit systems
  • Includes data and power cable for complete IDE-to-SATA conversion

IDE-to-SATA adapter for legacy drives

The Vszerda 39-pin adapter converts 3.5-inch IDE hard disks, optical drives and recorder drives to a SATA interface so they can connect directly to a motherboard SATA port. It works with IDE burners and parallel ATA devices up to 1000G capacity. No driver is required and the board is compatible with 32-bit and 64-bit Windows XP, 7 and 8 systems.

Replaces internal IDE cables and controllers

This card lets you keep using an existing IDE drive when the motherboard no longer provides an IDE header, avoiding a full drive replacement. The jump is worth it when you need to recover data from an old recorder or extend the life of a legacy optical drive without hunting for a vintage controller. The adapter supports SATA 1 and SATA 2 generations for broad motherboard compatibility.

Limited by parallel ATA throughput

The converted drive remains bound by the original IDE transfer rate, so sustained throughput will not exceed the parallel ATA ceiling. The jumper on the source device must be set to MASTER position for the adapter to function correctly. Drives larger than 1000G are not supported and the board does not add features such as native command queuing or hot-plug capability.

Highlights

  • Connect 3.5-inch IDE drives to SATA motherboard ports
  • Supports parallel ATA drives up to 1000G capacity
  • Plug-and-play operation with no driver installation needed
  • Compatible with Windows XP, 7, 8 on 32-bit and 64-bit systems
  • Includes data and power cable for complete IDE-to-SATA conversion

Specifications

No published specifications for this item yet.

Questions about this item

What size hard drive bay does the 39-pin adapter fit?

The adapter measures 6 by 2.2 cm and is designed for 3.5-inch IDE hard drives or optical drives.

How do I install the IDE-to-SATA converter correctly?

Plug the adapter onto the drive's 39-pin IDE connector, attach the included data and power cables, then set the drive jumper to Master before powering on.

Will I need to replace the adapter if I upgrade to a larger drive?

The card supports parallel ATA drives up to 1000 GB; drives beyond that capacity would require a different solution.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.